Advertisement

Quick Links

SERVICE MANUAL
Ver 1.0 2000. 01
System
Compact disc digital audio system
Laser diode properties
Material: GaAlAs
Wavelength: λ = 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW (This output
is the value measured at a distance of 200 mm
from the objective lens surface on the optical
pick-up block with 7 mm aperture.)
D-A conversion
1-bit quartz time-axis control
Frequency response
20 - 20,000 Hz +1/–2 dB
(measured by EIAJ CP-307)
Output (at 4.5 V input level)
Headphones (stereo minijack)
Approx. 5 mW + Approx. 5 mW
at 16 ohms
MICROFILM
Model Name Using Similar Mechanism
CD Mechanism Type
Optical Pick-up Name
SPECIFICATIONS
Power requirements
For the area code of the model you purchased,
check the upper left side of the bar code on the
package.
• Two Sony NC-WMAA rechargeable
batteries: 2.4 V DC
• Two LR6 (size AA) batteries: 3 V DC
• AC power adaptor (DC IN 4.5 V jack):
US, CND model: 120 V, 60 Hz
AEP, E13 model:
220 - 230 V, 50/60 Hz
UK model: 230 - 240V, 50 Hz
AUS model: 240 V, 50 Hz
E33 model: 100 - 240 V, 50/60 Hz
• Sony DCC-E245 car battery cord for use on
car battery: 4.5 V DC
– 1 –
D-SJ01
US Model
Canadian Model
AEP Model
UK Model
E Model
Australian Model
D-E01/EJ01
CDM-3022EBG
DAX-22EG
Battery life * (approx. hours)
(When you use the CD player on a flat and stable
surface.)
Playing time varies depending on how the CD
player is used.
When using
G-PROTECTION function
off
Two NC-WMAA
12
(charged for
about 2.5 hours**)
NH-WM2AA
25
(charged for
about 4 hours**)
Two alkaline
40
batteries LR6
*
Measured value by the standard of EIAJ
(Electronic Industries Association of Japan).
** Charging time varies depending on how the
rechargeable battery is used.
– Continued on next page –
PORTABLE CD PLAYER
on
11
23
37

Advertisement

Table of Contents
loading

Summary of Contents for Sony D-SJ01

  • Page 1 20 - 20,000 Hz +1/–2 dB E33 model: 100 - 240 V, 50/60 Hz Two alkaline (measured by EIAJ CP-307) • Sony DCC-E245 car battery cord for use on batteries LR6 Output (at 4.5 V input level) car battery: 4.5 V DC...
  • Page 2: Table Of Contents

    CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE • Never reuse a disconnected chip component. REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY • Notice that the minus side of a tantalum capacitor may be DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU damaged by heat.
  • Page 3: Service Note

    Apply SONY grease SGL-505 (7-662-010-04) to the ring at the During repair, pay attention to electrostatic breakdown and also points specified in the figure with an applicator or other means.
  • Page 4: General

    SECTION 2 GENERAL This section is extracted from instruction manual. – 4 –...
  • Page 5 – 5 –...
  • Page 6: Disassembly

    SECTION 3 DISASSEMBLY • This equipment can be removed using the following procedure. Hold Board Cabinet (M) Switch Unit CD Mechanism Deck Optical Pick-Up Main Board Control Board Note : Follow the disassembly procedure in the numerical order given. 3-1. HOLD BOARD Note : When installing, fit the lever (SW) and switch (S951) lever (SW) S951...
  • Page 7: Switch Unit

    3-3. SWITCH UNIT 4 switch unit 2 M 1.7x4 3 cover, lid 1 CN801 3-4. CD MECHANISM DECK 4 cd mechanism deck 1 CN503 2 CN502 3 CN501 – 7 –...
  • Page 8: Main Board

    3-5. MAIN BOARD 3 knob (AVLS) 4 MAIN board 1 CN802 3-6. CONTROL BOARD 3 cover, button 1 screw (B2) 5 button, control 6 screw (B1.4) 4 screw (B1.4) 7 CONTROL board – 8 –...
  • Page 9: Optical Pick-Up

    3-7. OPTICAL PICK-UP 6 optical pick-up 2 rack 1 M1.4x1.8 5 shaft, standard 4 bracket assy, sled 3 M1.4x4 – 9 –...
  • Page 10: Test Mode

    SECTION 4 TEST MODE 4-1. GENERAL INFORMATION In this set, the functions and audio capabilities can be checked by entering the TEST MODE. 4-2. TEST MODE 4-2-1. Setting the Test Mode 1. Switch positions OPEN switch : OPEN HOLD switch : OFF AVLS switch : OFF 2.
  • Page 11: Electrical Adjustments

    SECTION 5 SECTION 6 ELECTRICAL ADJUSTMENTS DIAGRAMS CD section adjustments are done automatically in this set. 6-1. IC PIN DESCRIPTION Pin No. Pin Name Pin Description In case of operation check, confirm that focus bias. • IC801 TMP88CM22F (SYSTEM CONTROLLER) 53 –...
  • Page 12: Block Diagram -Cd Section

    D-SJ01 6-2. BLOCK DIAGRAM — CD SECTION — RF AMP, DIGITAL SIGNAL PROCESSOR, DIGITAL SERVO PROCESSOR, D-RAM CONTROLLER IC601 DETECTOR WDCK DOUT DIGITAL WFCK D-RAM IC602 RFDC RFAC XTAO XTAI D0-D3 OP VCC RFAC FOCUS/TRACKING COIL DRIVER OPTICAL PICK-UP SLED MOTOR DRIVER...
  • Page 13: Block Diagram -Power Supply Section

    D-SJ01 6-3. BLOCK DIAGRAM — POWER SUPPLY SECTION — VCC2_ON D404 POWER CONTROL +3V POWER IC401 (1/2) VCC +3V SWITCH Q401, 405 DTC2D LOW BATTERY SYNC SYNC (Page 15) D411 DETECTOR DTC1D IC404 DATA SDTO BATM1 (Page 15) (Page 14)
  • Page 14: Printed Wiring Boards -Main Section

    D-SJ01 6-4. PRINTED WIRING BOARDS — MAIN SECTION — RECHARGEABLE BATTERY RECHARGEABLE BATTERY NC-WMAA NC-WMAA 1.2V 700mAh 1.2V 700mAh M901 SLED MOTOR M902 SPINDLE MOTOR S901 S903 S902 J401 DC IN 4.5V SWITCH UNIT S904 J302 • Semiconductor Location Ref. No.
  • Page 15 D-SJ01 OPTICAL PICK-UP BLOCK (DAX-22EG) Note on Printed Wiring Boards: • Y : parts extracted from the conductor side. • : Through hole. • b : Pattern from the side which enables seeing. Caution: Pattern face side: Parts on the pattern face side seen from the (Side B) pattern face are indicated.
  • Page 16 D-SJ01 6-5. SCHEMATIC DIAGRAM — MAIN SECTION (1/2) — • Refer to page 25 for Waveforms. • Refer to page 27 for IC Block Diagrams. (Page 26) – 23 – – 24 –...
  • Page 17: Schematic Diagram -Main Section (1/2)

    D-SJ01 6-6. SCHEMATIC DIAGRAM — MAIN SECTION (2/2) — • Refer to page 28 for IC Block Diagrams. (Page 23) • Waveforms (Play mode) 2Vp-p 2Vp-p 0.5±0.15Vp-p 2Vp-p 1.9Vp-p 0.5µsec/div 16.9MHz 0.05µsec/div 2µsec/div TP425 (SCK) 0.5µsec/div 20µsec/div 5µsec/div (MDP) TP614 (RF)
  • Page 18: Ic Block Diagrams

    IC601 CXD3027R 6-7. IC Block Diagrams IC402 MPC17H71MTAEL 120 119 118 117 116 115 114 113 112 111 110 109 108 107 106 105 104 103 102 101 100 99 98 97 96 95 94 93 92 91 FEEDBACK PATTERN BEMF GENERATOR SEPARATOR...
  • Page 19 IC401 MPC17A52FTA 58 57 56 SWITCHING CHARGING BATTERY POWER VOLTAGE DETECTOR DOWN SIDE CIRCUIT 3 CIRCUIT PRE-DRIVER DCIN PRE- UP SIDE VLG3 DRIVER PRE-DRIVER RF21 REFERENCE PAPC APCREF UP SIDE BAND GAP PRE-DRIVER VREF REFERENCE INM1 DTC1D DTC2D MODE2 DOWN SIDE PRE-DRIVER SWITCHING LOW VOLTAGE DETECTOR...
  • Page 20: Exploded Views

    SECTION 7 EXPLODED VIEWS NOTE: • The mechanical parts with no reference • Accessories and packing materials are The components identified by mark 0 or dotted line with mark. number in the exploded views are not supplied. given in the last of this parts list. 0 are critical for safety.
  • Page 21: Cabinet (Rear) Section

    7-2. CABINET (REAR) SECTION CDM-3022EBG Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark X-4952-423-1 ARM ASSY, CLICK 3-043-748-01 SCREW (B1.4) 4-908-792-61 SCREW (B2) 4-225-312-01 BUTTON, CONTROL 4-225-305-01 CABINET (REAR) 4-225-319-01 COVER, BUTTON 4-225-306-01 PACKING (DC-IN) 3-044-224-01 SHEET (REAR), ADHESIVE 3-326-520-01 PACKING, HP JACK 4-225-324-01 LEVER (OPEN) 4-225-315-01 PLATE (REAR), ORNAMENTAL...
  • Page 22: Cd Mechanism Deck Section (Cdm-3022Ebg)

    7-3. CD MECHANISM DECK SECTION (CDM-3022EBG) M902 M901 The components identified by Les composants identifiés par une mark 0 or dotted line with mark. marque 0 sont critiques pour la 0 are critical for safety. sécurité. Replace only with part number Ne les remplacer que par une piéce specified.
  • Page 23: Electrical Parts List

    SECTION 8 HOLD MAIN ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in • Items marked “*” are not stocked since The components identified by mark 0 or dotted line with mark. the parts list may be different from the they are seldom required for routine service.
  • Page 24 MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark C601 1-164-156-11 CERAMIC CHIP 0.1uF D406 8-719-077-01 DIODE CRS03(TE85L) C602 1-162-967-11 CERAMIC CHIP 0.0033uF 10% D409 8-719-049-09 DIODE 1SS367-T3SONY C604 1-125-891-11 CERAMIC CHIP 0.47uF D411 8-719-049-09 DIODE 1SS367-T3SONY C605 1-107-826-11 CERAMIC CHIP 0.1uF...
  • Page 25 MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark < TRANSISTOR > R422 1-216-845-11 METAL CHIP 100K 1/16W R423 1-216-857-11 METAL CHIP 1/16W Q401 8-729-023-89 FET 2SJ305(TE85L) R424 1-216-837-11 METAL CHIP 1/16W Q402 8-729-921-73 TRANSISTOR 2SD1781K-QR R426 1-216-861-11 METAL CHIP 2.2M...
  • Page 26 MAIN SWITCH Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R613 1-216-864-11 METAL CHIP 1/16W S805 1-570-711-11 SWITCH, SLIDE (G-PROTECTION) R614 1-216-841-11 METAL CHIP 1/16W R615 1-216-837-11 METAL CHIP 1/16W < VARISTOR > R616 1-216-845-11 METAL CHIP 100K 1/16W R617...
  • Page 27 Ref. No. Part No. Description Remark ACCESSORIES & PACKING MATERIALS ******************************** 1-418-261-11 ADAPTOR, AC (AC-E455F) (AEP,E13) 1-418-264-11 ADAPTOR, AC (AC-E455A) (AUS) 1-467-009-21 ADAPTOR, AC (AC-E455) (US,CND) 1-467-550-24 ADAPTOR, AC (AC-E455A) (E33) 1-473-115-11 ADAPTOR, AC (AC-E455D) (UK) 1-569-007-11 ADAPTOR, CONVERSION 2P (E33) 1-756-035-51 BATTERY PACK (NC-WMAA) (E13,E33,AUS) 1-756-035-61 BATTERY PACK (NC-WMAA) (AEP,UK) 1-756-035-71 BATTERY PACK (NC-WMAA) (US,CND)
  • Page 28 D-SJ01 Sony Corporation 2000A0486-1 9-927-640-11 Personal Audio Division Company Printed in Japan C2000.1 – 38 – Published by General Engineering Dept.

Table of Contents