EnGenius EAP300 User Manual page 52

Wireless Advanced
Data Rate Select a data rate from the drop-down list. The data rate affects throughput. If you select a low
data rate value, for example, the throughput is reduced but the transmission distance increases.
Transmit Power Set the power output of the wireless signal.
RTS/CTS Threshold Specify the threshold package size for RTC/CTS. A small number causes RTS/CTS packets to be
sent more often and consumes more bandwidth.
Distance Specify the distance between Access Points and clients. Longer distances may drop high-speed
connections.
Aggregation Merges data packets into one packet. This option reduces the number of packets, but increases
packet sizes.
Wireless Traffic Check this option to enable wireless traffic shaping. Traffic shaping regulates the flow of packets
Shaping leaving an interface to deliver improved Quality of Service.
Incoming Traffic Limit Specify the wireless transmission speed used for downloading.
Outgoing Traffic Limit Specify the wireless transmission speed used for uploading.
Total Percentage It shows how much percentage has been used.
SSID #1~#8 Specify the wireless transmission speed used for each SSID.
Client Limit Check Enable and enter a number to limit the maximum client connection (The maximum is 127).
Note: Only applicable in Access Point, WDS AP and Repeater mode.
Accept / Cancel Click Accept to confirm the changes or Cancel to cancel and return previous settings.