Toro 04613 Operator's Manual page 6

Figure 8
1. Height-of-cut arm
2. Locknut
2. Loosen the nut on the gauge bar and set the height
adjusting bolt to the desired height-of-cut (Figure 9).
The distance between the bottom of the bolt head and
the face of the bar is the height-of-cut.
Figure 9
1. Gauge bar
2. Height adjusting bolt
3. Hook the bolt head onto the cutting edge of the
bedknife and rest the rear end of the bar onto the rear
of the roller (Figure 10).
G020095
3. Adjusting bolt
3. Nut
1. Gauge bar
4. Rotate the adjusting bolt on the height-of-cut arms
until the front roller contacts the gauge bar. Adjust
both ends of the roller until the entire roller is parallel
to the bedknife.
Important: When set properly, the rear and front
rollers will contact the gauge bar and the bolt head
will be snug against the bedknife. This ensures
that the height-of-cut is identical at both ends of
the bedknife.
5. Tighten the nuts to secure the adjustment. Do not
overtighten the nuts. Tighten them enough to remove
play from the washer.
Note: Use the following chart to determine which
bedknife is best suited for the desired height of cut.
Recommended Bedknife/Height of Cut Chart
Bedknife Part Number
Edgemax 115-1880
Micro-cut
(Standard)
Edgemax 115-1881
Tournament
(Optional)
Micro-cut 93-4262
(Optional)
Tournament 93-4263
(Optional)
Extended 108-4303
Micro-cut
(Optional)
Extended 108-4302
Tournament
(Optional)
Low-cut 93-4264
(Optional)
High-cut 94-6392
(Optional)
Fairway 63-8600
(Optional)
6
Figure 10
Height of Cut
1.5–4.7 mm
(0.062–0.188 inch)
3.1–12.7 mm
(0.125–0.500 inch)
1.5–4.7 mm
(0.062–0.188 inch)
3.1–12.7 mm
(0.125–0.500 inch)
1.5–4.7 mm
(0.062–0.188 inch)
3.1–12.7 mm
(0.125–0.500 inch)
4.7–25.4 mm
(0.188–1.00 inch)
7.9–25.4 mm
(0.312–1.00 inch)
9.5–25.4 mm
(0.375–1.00 inch)