Gigabyte GA-X170-Extreme ECC User Manual page 73

Step 5:
Enter the array capacity and press <Enter>. Finally press <Enter> on the Create Volume item to begin creating
the RAID array. When prompted to confirm whether to create this volume, press <Y> to confirm or <N> to
cancel (Figure 13).
Intel(R) Rapid Storage Technology enterprise - SATA Option ROM - 4.3.0.1018
Copyright (C) 2003-14 Intel Corporation. All Rights Reserved.
WARNING : ALL DATA ON SELECTED DISKS WILL BE LOST.
[hi]-Change
When completed, you can see detailed information about the RAID array in the DISK/VOLUME INFORMATION
section, including the RAID level, stripe block size, array name, and array capacity, etc. (Figure 14)
Intel(R) Rapid Storage Technology enterprise - SATA Option ROM - 4.3.0.1018
Copyright (C) 2003-14 Intel Corporation. All Rights Reserved.
1. Create RAID Volume
2. Delete RAID Volume
RAID Volumes :
ID Name Level
0 Volume0 RAID0(Stripe)
Physical Devices :
ID Device Model
1 Hitachi HDS72105
2 Hitachi HDS72105
[hi]-Select
To exit the RAID BIOS utility, press <Esc> or select 5. Exit in MAIN MENU.
Now, you can proceed to install the SATA RAID/AHCI driver and operating system.
[ CREATE VOLUME MENU ]
Name : Volume0
RAID Level : RAID0(Stripe)
Disks : Select Disks
Strip Size : 128 MB
Capacity : 884.9 GB
Create Volume
[ HELP ]
Are you sure you want to create this volume? (Y/N) :
Press ENTER to create the specified volume.
[TAB]-Next [ESC]-Previous Menu
Figure 13
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
Strip
128KB
Serial #
JP1532ER04EJTK
JP1532ER046AGK
[ESC]-Exit
Figure 14
- 73 -
[ENTER]-Select
3. Reset Disks to Non-RAID
4. Mark Disks as Spare
5. Exit
Size Status Bootable
884.9GB Normal Yes
Size Type/Status(Vol ID)
465.7GB Member Disk(0)
465.7GB Member Disk(0)
[ENTER]-Select Menu
Configuring a RAID Set