Assembly; Loop Handle Installation - Toro 53008 Operator's Manual

Assembly

Loop Handle Installation

The loop handle kit contains a package of four screws and
nuts, a rubber sleeve and the bottom clamp for the loop
handle (Fig. 5).
1. Slip the rubber sleeve around the shaft approximately
9 inches (22.8 cm) from the end of the stop
switch/throttle trigger assembly for an initial handle
position (Fig. 5).
2. Rotate the rubber sleeve so the split is to one side
(Fig. 5).
3. Place the loop handle and the bottom clamp over the
rubber sleeve (Fig. 5).
4. Install the four screws and nuts. Leave the screws
finger-tight (Fig. 5).
Figure 5
1. Loop Handle
2. Screw (4)
3. Rubber Sleeve
4. Bottom Clamp
5. Nut (4)
5. Reposition the loop handle up or down the drive shaft
to the most comfortable position, but no closer than 9
inches (22.8 cm) from the end of the stop switch
(Figs. 5 and 6).
6. Tighten the screws and nuts (Fig. 5).
Figure 6
8