Panasonic NH-P8ER1 Operating & Installation Instructions Manual page 38

Problem/error
The dryer does not work.
There is voltage at the
mains socket, but the
drum does not spin and
the dryer does not work.
Laundry is not dried, or
drying time is longer
than 4h.
Unevenly dried laundry.
Error in the drum
lighting.
On display: F3
On display: F4
Write down the failure/error code: F0, F1, or F2, disconnect the appliance and call the
nearest authorised service centre.
38
NH-P8ER1_WGB_En.indd 38
Cause
• No voltage from the mains
socket.
• Programme was not started
in accordance with the
instructions.
• The door is not properly
closed.
• Water container is full.
• Delayed start function has
been selected.
• Filters are not clean. The
room is not sufficiently
ventilated.
• Inappropriate temperature
in the room.
• Laundry was not sufficiently
wrung or spun.
• Amount of laundry dried in
the appliance is too large or
insufficient.
• The amount of laundry
dried at a time is too large.
• Drying the pieces of
different thicknesses.
• Drying the different types
of laundry.
• The light does not turn
on when the dryer door is
opened.
• Full water container.
• If the water container is
empty, there is a pump
failure.
• Clogged filters.
• If the filters are clean,
there may be a compressor
failure.
What to do ...?
• Check if the mains plug is
correctly inserted into the mains
socket.
• Check the fuse.
• Reread the instructions for use
again.
• Push the door towards the
appliance.
• Empty the water container
(see section Cleaning and
Maintenance).
• Wait until the time indicated on
the display elapses.
• Clean the filters.
• Install the dryer in an
appropriate room (see section
Installation ...)
• Check if the temperature in
the room where the dryer is
installed is too high (over 25 °C)
or too low (below 10 °C).
• Laundry inserted into the dryer
was not sufficiently wrung or
spun, or an inappropriate drying
programme was selected.
• Use an appropriate programme
or use the timed programme.
Increase the final level of
dryness for the selected
programme (intensive drying
function).
• Make sure the laundry is sorted
by type and size of items given
the selected programme (see
section Drying – Preparing the
Laundry and the Programme
Table).
• Disconnect the dryer from mains
power and call an authorised
service centre.
• Empty the water container
(see section Cleaning and
Maintenance).
• Disconnect the appliance and
call an authorised service centre.
• Clean the filters.
• Disconnect the appliance and
call an authorised service centre.
2015/08/24 10:55:58