Checking The Torque Of The Front Wheel Nuts; Greasing The Traction Unit; Install Rear Weight - Toro 30626 Groundsmaster 328-D Operator's Manual

Checking the Torque of the
Front Wheel Nuts
Warning
Failure to maintain proper torque of the front
wheel nuts could result in failure, loss of wheel, or
personal injury.
Torque the front wheel nuts to 45–55 ft.-lb.
(61–75 NVm) after 1–4 hours of operation and
again after 10 hours of operation. Torque every
250 hours thereafter.
To comply with CEN standard EN 836:1997, ISO standard 5395:1990 and ANSI/OPEI B71.4–2004 Standard, rear weight
must be added to rear of two wheel drive traction units. Use chart below to determine weight requirements. Order parts from
your local Authorized Toro Distributor. No additional weight is required on four wheel drive models.
Note: A rear weight kit, part no. 24–5780 is supplied with Model No. 30630.
Two Wheel Drive
Cutting Unit Rear Weight
Description Required
72" Side Discharge 70 lb.
(Model No. 30722)
72" Rear Discharge 70 lb.
(Model No. 30710)
Guardian 72" 70 lb.
Recycler
(Model No. 30716)

Greasing the Traction Unit

Before the machine is operated, it must be greased to assure
proper operating characteristics; refer to Lubrication
Maintenance. Failure to grease the machine will result in
premature failure of critical parts.
Note: After setup has been completed, remove protective
edging (used for shipping) from fenders.

Install Rear Weight

Weight Part
Number
24–5780
(two 35 lb. weights and mounting hardware)
24–5780
(two 35 lb. weights and mounting hardware)
24–5780
(two 35 lb. weights and mounting hardware)
22
Weight Description
Rear Weight Kit
Rear Weight Kit
Rear Weight Kit
Qty.
1
1
1