Sign in today to find solutions:

Don't have an account? Sign up

Atwood Mobile Products HYDRO FLAME 2540 User Manual

Atwood mobile products furnace user manual.

 
ENGLISH, FRANCAIS
THIS INSTRUCTION MANUAL IS FOR USE BY AN AUTHORIZED SERVICE
TECHNICIAN TO INSTALL AN ATWOOD
:
INSTALLER
LEAVE THIS MANUAL WITH APPLIANCE
:
CONSUMER
RETAIN THIS MANUAL FOR FURTHER REF
.
ERENCE
This furnace design has been certified for installation in recre-
ation vehicles as a MSP Category III furnace. Follow this
installation instruction to insure safe operation of the furnace.
Failure to install furnace according to this installation instruc-
tion nullifies the furnace warranty.
SAFETY ALERT SYMBOLS
Safety Symbols alerting you to potential personal safety hazards.
Obey all safety messages following these symbols.
WARNING
avoid possible
injury or death
WARNING: If the information in this manual is
not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of
life.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
• Evacuate all persons from vehicle.
• Shut off gas supply at gas container or source.
• Do not touch any electrical switch, or use any
phone or radio in vehicle.
• Do not start vehicle's engine or electric generator.
• Contact nearest gas supplier or qualified Service
Technician for repairs.
• If you cannot reach a gas supplier or qualified
Service Technician, contact the nearest fire
department.
• Do not turn on gas supply until gas leak(s) has
been repaired.
Installation and service must be performed by a
qualified Service Technician, Service Center or
gas supplier.
9
(et Canada)
- hydro flame
FURNACE
TM
CAUTION
avoid possible
injury and/or property damage
Patent No US 6,464,000. 6,719,207. Other Patents Pending
.
FURNACE SPECIFICATIONS
DIMENSIONS
.
WEIGHT
-
MINIMUM CLEARANCE TO FLOORBOARDS
&
SIMILAR COMBUSTIBLE BUILDING MATERIALS
SAFETY INFORMATION
FURNACE INSTALLATION
WALL CUTOUT OPTIONS
VENT INSTALLATION
DUCTING
HORIZONTAL & VERTICAL
Required Minimum Discharge Chart
Flexible Ducting
Floor Ducting
OPTIONAL INSTALLATION
PROPANE GAS CONNECTION
ELECTRICAL CONNECTIONS
Conductor Sizing Table
Thermostat Installation
SYSTEM CHECK TESTS
DIAGNOSTIC CHART
PROPANE GAS PRESSURE
STATIC PRESSURE
..........................................................................
WIRING DIAGRAM
............................................................................
ILLUSTRATIONS
REPLACEMENT PARTS LIST
SPECIFICATIONS
2540
MODEL
BTU Input
Duct Static Pressure
12 Volt Amperage (AMPS)
Watts
Power Supply (
VOLT DC
Recommended Return Air
MINIMUM RETURN AIR
DIMENSIONS
ALL MODEL
Casing
Door
Recess Bezel
VENT
FLOORBOARDS, WALLS & SIMILAR COMBUSTIBLE BUILDING MATERIALS
MUST BE PROVIDED THE FULL LENGTH AND WIDTH OF UNIT
HORIZONTAL
TOP
VERTICAL
TOP
1
LITERATURE NUMBER
hydro flame
2 Stage Series Furnace
Technical Installation Manual
INDEX
..............................................................
..................................................................
........................................................................
,
,
WALLS
..............................
..................................................................
..................................................................
......................................
HORIZONTAL & VERTICAL
(MODELS WITHOUT DOOR) HORIZONTAL & VERTICAL
....................................................
............................................
......................................................................
........................................................................
..................................
-
BOTTOM DISCHARGE KIT
............................................................
..............................................................
............................................................
..........................................................
....................................................................
......................................................................
..............................................................
........................................................................
..............................................
&
DRAWING
LOW
25,000
.10˝ W.C.
7.2
86
)
12
80 in
2
80 in
2
WIDTH
HEIGHT
DEPTH
16-1/2˝
9-1/8˝
23 1/2˝ - 26˝
19-1/4˝
9-1/4˝
1/4˝
20-9/16˝
11-1/2˝
5-3/8˝
MINIMUM CLEARANCE TO
----1/2˝
3/16˝
BOTTOM
SIDES
----1/2˝
----0˝
BOTTOM
SIDES
MPD 31230
TM
8900-III-LD
2540
MODEL
•Installation
Effective 1/08
1
1
1
1-2
1-2
2
2
................
2
2-3
3
3
3
3
3
3
3
3-4
4
4
4
4
4
5
6
(W.C. = Water Column)
HIGH
40,000
.10˝ W.C.
16.8
202
12
80 in
2
80 in
2
WEIGHT
39 lbs
FURNACE
46 lbs
SHIPPING
----1˝
--1/2˝
REAR
----1˝
--1/2˝
REAR

Summary of Contents

  • Page 1

    CONSUMER RETAIN THIS MANUAL FOR FURTHER REF ERENCE This furnace design has been certified for installation in recre- ation vehicles as a MSP Category III furnace. Follow this installation instruction to insure safe operation of the furnace. Failure to install furnace according to this installation instruc- tion nullifies the furnace warranty.

  • Page 2

    2. Drill 3-1/2˝ diameter hole through side wall of coach. 3. Remove vent and vent ring from furnace. 4. Insert furnace from backside of wall. Line up hole in wall with hole for vent to furnace. 5. Apply sealant to back of vent ring and vent cap base.

  • Page 3

    ( PROPANE GAS CONNECTION 1. Connect gas line to fitting on top rear of furnace. Be sure all male pipe threads, other than flare fittings, are treated with a sealing com- pound resistant to the action of propane (LP) gas.

  • Page 4

    2. Do not install the thermostat where there are unusual heating condi- tions: such as direct sunlight, heat producing appliances (television, radio, wall lamp, etc.) or a furnace or air conditioner supply register. . Separate the thermostat body from the ATTACHING THE WALL THERMOSTAT sub-base by gently squeezing the top and bottom.

  • Page 5

    Casing Static Check Point Gas Line (Conduite de gaz) ( E X R I E I D E H I C AVANT DU VEHICULE...

  • Page 6

    8900-III-LD 2 Stage Series Furnace Model 2540 HEAT COOL DRAWING DESCRIPTION Blower Wheel Burner Assembly ON/OFF Switch / Circit Breaker Valve Coil Replacement (DC) Combustion Wheel Dual Thermostat Valve Vent Assembly Electronic Ignition Board Duct Adapters Duct Cover Plate...

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: