Displaying Parameters; Table 1. How To Display Parameters - Omega Engineering wall mount Multi-Channel DPS3300 User Manual

DISPLAYING PARAMETERS

DPS3300 Series keeps track of various parameters and these may be displayed by pushing appropriate keys on the front
panel. The parameters that are tracked are:
a) Channel's high peak
b) Channel's low peak
c) Elapsed time
c) Channel with the highest reading
Table 1 explains how to display the above mentioned parameters.

Table 1. How to Display Parameters

TO DISPLAY
1) Channel's high peak
2) Channel's low peak
3) Rate of process change
4) Channel deviation
5) Channel differentials
6) Elapsed time
7) Channel with highest
process reading
8) Channel with lowest
process reading
9) Scan
10)Hold
d) Channel with the lowest reading
e) Process deviation of each channel from pre-programmed setpoint
f) Process differential of a channel with respect to any other channel
g) Rate of process change per minute for each channel
PERFORM FOLLOWING STEPS
a) Select channel whose high peak is desired (push CH SEL key)
b) Push HI/LO key once
a) Select channel whose low peak is desired (push CH SEL key)
b) Push HI/LO key twice --- 1st push displays high peak,
a) Select channel whose Rate is desired (push CH SEL key)
b) Push DATA key once.
a) Select desired channel (by pushing CH SEL key)
b) Push DATA key twice --- 1st push displays rate,
2nd push, deviation.
a) Select desired channel (by pushing CH SEL key).
b) Push DATA key three times -- 1st push displays rate,
2nd push: deviation, 3rd push : differential.
c) Each additional push moves to the differential between selected
channel and the next channel.
d) e.g. the sequence for channel 1 is: RATE, CH1-SP, CH1-CH2,
CH1-CH3, CH1-CH4, CH1-CH5, CH1-CH6, CH1-CH7
a) Push TIME key.
a) Push HI/LO key once
a) Push HI/LO key twice ----1st push:
a) If the unit is holding, push the SCN/HLD key once.
a) If the unit is scanning, push the SCN/HLD key once.
2nd push , low peak.
high channel
2nd push: low channel.
Page 6