Table of Contents
Advertisement
U L
C
US LISTED
R
IND. CONT. EQ.
51EB
GENERAL DESCRIPTION
The LDP63100 is a versatile display that can increase productivity by
offering the plant floor or production area a large visual display of their current
status. Whether your measurement is voltage, current, process, temperature, or
strain gage, the LDP63100 can satisfy your requirement. Plug-in option cards
can add alarms, analog output, and communication/bus capabilities, making the
LDP63100 a truly Intelligent Panel Meter.
SAFETY SUMMARY
All safety regulations, local codes and instructions that appear in this and
corresponding literature, or on equipment, must be observed to ensure personal
safety and to prevent damage to either the instrument or equipment connected
to it. If equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
The protective conductor terminal is bonded to conductive
parts of the equipment for safety purposes and must be
connected to an external protective earthing system.
CAUTION: Risk of Danger
Read complete instructions prior to
installation and operation of the unit.
DIMENSIONS In inches (mm)
CAUTION: Risk of electric shock.
3
LARGE LED DISPLAY READABLE TO 180 FEET
VARIOUS ANALOG INPUT MODULES;
DC VOLTAGE AND CURRENT
PROCESS SIGNALS
TRUE RMS VOLTAGE AND CURRENT
THERMOCOUPLE OR RTD
STRAIN GAGE/BRIDGE
ALARMS, ANALOG OUTPUT, AND COMMUNICATION
PROGRAMMABLE USER INPUTS
UNIVERSAL AC POWERED (85 to 250 VAC)
PROGRAMMING SOFTWARE
NEMA 4X/IP65
SPECIFICATIONS
Input specifications, wiring, and programming information is contained in
the corresponding literature shipped with the ordered model.
1. DISPLAY: 4" (101 mm) Red LED
5-Digit: -19999 to 99999
2. POWER REQUIREMENTS:
AC Input Modules: 85 to 250 VAC, 50/60 Hz, 18 VA
LDP63100 Display: 85 to 250 VAC, 50/60 Hz, 10 VA
3. ANNUNCIATORS:
Display Indication: Three vertical dots on the left side of the unit identify
the displays for the following modes:
TOP
Maximum
MIDDLE
Minimum
BOTTOM
Total
Setpoint Indication: Four vertical dots on the right side of the unit identify
the setpoint "ON" condition, with SP 1 being the top position through SP
4 at the bottom.
4. LDP63100 Programming: The unit is a large display, designed to be
remotely mounted. Therefore, the unit does not have a programming keypad.
Unit programming should be accomplished by one of the following methods:
Rear Terminal Block: External switches can be wired via the terminal block
to allow unit programming. A minimum of 3 switches would be required.
Optional Programming Remote (LDP6-PGM): This option provides a 10
foot interconnecting cable and programming box. The Programming
Remote contains buttons allowing easy programming of the display.
Optional Serial Programming: You can purchase an RS232 or RS485 Comms
Card and program the unit via Crimson, a Windows
program.
®
based software
Advertisement
Table of Contents
