Utility Setup Menu - Omega Engineering Rercorder RD8300 User Manual

Section 4 – Functional Description
There are 5 button icons in the Task Bar. They vary according to the status of the recorder. They are from left
to right:
Utility Setup Menu Button – This button takes the user to the
can configure and control the recorder.
Alarm Contacts Reset Button – This icon shows the status of the optional output contacts. If any
contact is active, this icon will be
latched output contact that is reset enabled. User must be logged in to use.
Alarm Log Button – Pressing this button changes the Live Display to the
Log. The icon will change to reflect a graphic display when the next press will return to the live
display. When logged in as administrator there is an extra display – the Activity Log.
Alarm Accept Button – This icon indicates the status of the recorder alarms and acts as the Alarm
Accept button. Pressing this button silences the audible alarm tone. User must be logged in to use.
Refer to the
When GREEN
When AMBER
When RED
Record Icon – This icon indicates the recorder record mode. It changes according to what the
current record status is. Refer to the
The GREEN
The AMBER
The RED
4.2

Utility Setup Menu

Tapping the Utility Setup Menu Icon on the left of the Task Bar brings up the Utility Setup Menu as
shown below. Tapping the icon a second time returns to the original display.
The Utility Setup Menu provides the user with several options. The number in the right hand corner of the blue bar
at the top of the menu is the system memory resource usage as a percentage of available. It does not include
added memory. It should be less than 80% for proper operation. Menu choices are as follows:
Alarms section for more detail.
it indicates that there are no alarms present.
it indicates there are no alarms but the audible Alarm Tone has been muted.
it indicates there are alarms present OR the alarms have been disabled.
background indicates that the recorder is currently NOT recording.
background indicates that the recorder is currently ARMED but is NOT recording.
background indicates that the recorder is currently RECORDING. It will blink slowly.
Figure 4-2 Utility Setup Menu
red and show the contact closed. Pressing this icon will reset any
Record Setup section for more detail.
Page 25
Utility Setup Menu. Here the user
Event Log then the Alarm
09/11/2008 REV 0.99