Removing The Radiator Cover (All 125/150 Models); Checking The Antifreeze And Coolant Level - KTM 125 SX Owner's Manual

15 COOLING SYSTEM
15.4

Removing the radiator cover (All 125/150 models)

15.5

Checking the antifreeze and coolant level

Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the
engine and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If fuel is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of
children.
–
Position the matching radiator cover (
The larger catch is located at the top left.
Info
Do not use both radiator covers at the same time.
M01125-01
–
Position radiator shield
–
Mount and tighten screws
Guideline
Remaining screws, chassis
–
Mount and tighten screws
Guideline
Remaining screws, chassis
M01124-10
–
Remove screws
–
Remove screws
–
Take off radiator shield
–
Remove the radiator cover.
–
Position radiator shield
–
Mount and tighten screws
Guideline
Remaining screws, chassis
M01124-10
–
Mount and tighten screws
Guideline
Remaining screws, chassis
Condition
The engine is cold.
p. 92).

.

.

.

.

.

.

.

.

.
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
93