Sony HDR-CX360 Operating Manual page 182

Images are not output from the HDMI OUT

jack, if copyright protection signals are
recorded in the images.
When you are using the S VIDEO plug,

make sure the red and white plugs of the A/V
connecting cable are connected (p. 34).
The top, bottom, right, and left edges
of images are trimmed slightly on a
connected TV.
The LCD screen of your camcorder can

display recording images across the entire
screen (full pixel display). However, this may
cause slight trimming of the top, bottom, right,
and left edges of images when played back on
a TV which is not compatible with full pixel
display.
It is recommended you record images using

the outer frame of [Guide Frame] (p. 86) as
a guide.
The image appears distorted on the 4:3
TV.
This happens when viewing an image

recorded in the 16:9 (wide) mode on a 4:3 TV.
Set [TV Type] correctly (p. 92) and play back
the image.
Black bands appear at the top and bottom
of the screen of the 4:3 TV.
This happens when viewing an image recorded

in the 16:9 (wide) mode on a 4:3 TV. This is
not a malfunction.
The images being played back do not
appear on the LCD screen when you
connect the camcorder to a TV and play
back images.
Highlight Playback or a scenario will not

appear on the LCD screen of the camcorder
while it is connected to a TV and play back
images.
Copying/Connecting to other
devices
Images are not copied correctly.
You cannot copy images using the HDMI

cable (sold separately).
The A/V connecting cable is not connected

properly. Make sure to connect the cable to the
input jack of another device (p. 71).
Connecting to a computer
"PMB" cannot be installed.
Check the computer environment or

installation procedure required to install
"PMB. "
"PMB" does not work correctly.
Quit "PMB" and restart your computer.

The camcorder is not recognized by the
computer.
Disconnect devices from the USB jack of the

computer other than the keyboard, mouse,
and your camcorder.
Disconnect the Built-in USB Cable from the

computer and your camcorder, and restart
the computer, then connect the computer and
your camcorder again in the correct order.
When both the Built-in USB Cable and the

USB jack of the camcorder are connected
to the external devices at the same time,
disconnect one that is not connected to a
computer.
US
105