Driving The Tractor - Cub Cadet Z-Force SZ Operator's Manual

Using Jumper Cables To Start Engine
WARNING!
produce explosive gasses. Make certain the area is
well ventilated, wear gloves and eye protection, and
avoid sparks or flames near the battery.
If the battery charge is not sufficient to crank the engine,
recharge the battery. If a battery charger is unavailable and
the tractor must be started, the aid of a booster battery will be
necessary. Connect the booster battery as follows:
1. Connect the end of one cable to the disabled tractor
battery's positive terminal; then connect the other end of
that cable to the booster battery's positive terminal.
2. Connect one end of the other cable to the booster
battery's negative terminal; then connect the other end of
that cable to the frame of the disabled tractor, as far from
the battery as possible.
3. Start the disabled tractor following the normal starting
instructions previously provided; then disconnect the
jumper cables in the exact reverse order of their connection.
4. Have the tractor's electrical system checked and repaired
as soon as possible to eliminate the need for jump starting.
Stopping the Engine
1. Place the PTO switch in the disengaged position.
2. Engage the parking brake.
3. Move the throttle to the SLOW
engine to idle for about one minute.
4. Turn the ignition key to the STOP
the key from the ignition switch.
NOTE: Always remove the key from the ignition switch
to prevent accidental starting or battery discharge if the
equipment is left unattended.
5. Close the fuel shut-off valve.

Driving The Tractor

WARNING!
and sudden stops.
1. Release the parking brake. Move the throttle control lever
into the FAST position.
20 S 5— o
ection peration
Batteries contain sulfuric acid and
position and allow the
position and remove
Avoid sudden starts, excessive speed
2. To travel FORWARD, slowly press the forward drive pedal
forward until the desired speed is achieved. See Figure 5-2.
Parking Brake/Cruise Control Lever
Figure 5-2
3. To stop or slow down the tractor, take your foot off of the
forward or reverse drive pedal . To lock the parking
brake, press forward on the brake pedal, then press down
on the parking break/cruise control lever and then release
the brake pedal .
4. To use the cruise control:
e. Press down on the forward drive pedal .
f. While maintaining the desired speed press down on
the parking break/cruise control lever then release
the forward drive pedal
control.
7. To release the cruise control, press the brake
forward drive pedal .
NOTE: The forward
and reverse drive pedals
be used when the brake is partially engaged. When the
brake is locked the drive belt is disengaged but if the brake
is only part way back then the brakes are engaged but so
is the drive belt so transmission damage will occur if you
push forward or reverse.
8. To travel in reverse, check that the area behind is clear then
slowly push down on the reverse drive pedal
ball of your foot (NOT your heel) until the desired speed is
achieved. See Figure 5-2.
CAUTION:
Do NOT attempt to change the direction
of travel when the tractor is in motion. Always bring
the tractor to a complete stop before moving the
tractor from forward to reverse or vice versa.
WARNING!
Do not leave the seat of the tractor
without first placing the PTO knob in the
disengaged (OFF) position and engaging the
parking brake. If leaving the tractor unattended, also
turn the engine off and remove the ignition key.
Forward Drive Pedal
Reverse Drive Pedal
to activate the cruise
or the
must not
with the