Related Manuals for Omega VRT330
Summary of Contents for Omega VRT330
- Page 1 Instruction Manual VRT330 Please read the instructions carefully before using. Please keep the user’s guide where it is easily accessible. Design and product development may be upgraded without a public notice. www.omegajuicers.com OMEGA PRODUCTS, INC...
- Page 2 10. Be sure to turn switch to off position after each use of your juicer. Make sure the motor stops completely before disassembling. 11. Do not put your fingers or other objects into the juicer while it is in operation. If food becomes lodged in opening, use food plunger or another piece of fruit or vegetable to push it down.
-
Page 3: Table Of Contents
Please refer to the user’s guide when you are having technical difficulties or unsure of the usage of this product. Omega Products, Inc is not liable for any damages or injuries that may occur due to the lack of understanding of the user’s guide. -
Page 4: Attachment Listing
Attachment Listing Hopper Auger Strainer(white) Strainer(yellow) - less pulp Top Set Auto Cleaning Brush Bowl pulp ejection Notice Do not pre-operate before inputting materials or do not operate with an empty bowl. Crushing Base - more pulp Pusher IMPT As shown below, the hopper edge must point to “close”... -
Page 5: Assembly Instruction
Assembly instruction Strainer auto cleaning brush Red dot on the auto cleaning brush Red dot on the bowl Bowl Crushing Rib Auger Strainer Bowl Place the strainer into the auto cleaning brush Place the strainer + auto cleaning brush into the bowl make sure the red dot on the strainer and the red dot on the bowl is aligned Push in the Auger into the strainer... - Page 6 Assembly instruction Hopper The arrow on the hopper Red dot on the bowl Bowl Juice spout Base Assemble the hopper onto the bowl. ①Make sure the arrow on the hopper and the red dot on the bowl is aligned. ②Make sure the arrow on the hopper is pointing to close sign on the base.
-
Page 7: How To Use Vert Juicer
Assembly instruction Underneath the bowl, there is a yellow rubber gasket which allows all the juice to only discharge from the fresh juice spout. The rubber gasket is removable, simply grab onto one side of the rubber pad and pull out. Must connect the power cord. - Page 8 How to use “ON” Pusher “ON” Omega vert juicer The machine has three(3) settings. “On” starts motor, Start making juice. “Rev” is reverse. Only use when something is stuck and you need to unclog. “Off” is at center position. This allow the machine to turn off.
-
Page 9: Warning While Operating
Warning while operating Do not use longer than 30minutes at a time. Do not use anything as a pusher (fork , chopsticks, spoons, etc) other than the pusher itself. Remove any hard seeds. Do not operate with wet hands. Do not place the attachment parts in the dishwasher When the machine is stuck and not operable, Please…... -
Page 10: How To Disassemble And Clean
How to disassemble and clean Turn machine “Off”. Twist the hopper to unlock by grabbing the two ejections. Make sure the arrow is aligned with the open sign before pulling off the bowl. Order to disassemble. 1.Hopper 2.Auger 3.Strainer 4.Auto cleaning brush 5.Bowl Use the brush to clean... -
Page 11: Before Requesting For Repair Service
Before requesting for repair service Please check when Machine does not operate. The juice does not disch -arge suffciently or there is juice discharging from the pulp ejector. Machine is stopped. Making “squeaking” noise when making juice. The machine shakes. a. -
Page 12: Product Specification
Specification Product Name Model Name Voltage Frequency Power Consumption Electrical cord length Motor Weight Dimensions Standard usage time Omega Vert Juicer VRT330 120 V 60Hz 150w 70 rpm 4.592 ft + Single –Phase induction 11 lbs Width 7.08 in Length 9.84 in... - Page 14 Instruction Manual VRT330 Please read the instructions carefully before using. Please keep the user’s guide where it is easily accessible. Design and product development may be upgraded without a public notice. www.omegajuicers.com OMEGA PRODUCTS, INC...