Installing Or Removing The Lenovo Thinkserver Raid 110I Upgrade Key - Lenovo ThinkServer TD350 User Manual And Hardware Maintenance Manual

If your server has an SD module installed, do the following when you want to remove the SD module:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server. If
the server is in tower form factor, lay the server on its side for easier operation.
3. Remove the server cover. See "Removing the server cover" on page 72.
4. Remove the cooling shroud. See "Removing the cooling shroud" on page 75.
5. Remove any parts and disconnect any cables that might impede your operation.
6. Locate the SD module on the system board.
7. Press the two release tabs
SD module straight up and off the system board.
Figure 58. Removing the SD module
8. Push the SD card inward a little until you hear a click. Then, the SD card ejects. Gently slide the
card out of the card slot.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 180.

Installing or removing the Lenovo ThinkServer RAID 110i upgrade key

The Lenovo ThinkServer RAID 110i upgrade key expands the capability of the system board by activating
RAID 5 for the onboard SATA software RAID. You can purchase a Lenovo ThinkServer RAID 110i upgrade
key (hereinafter referred to as the RAID 110i upgrade key) from the Lenovo Web site at:
http://lenovoquickpick.com/usa/home/thinkserver/rack-and-tower-server
Installing the RAID 110i upgrade key
Attention: Do not open your server or attempt any repair before reading and understanding "Read this first: safety
information" on page iii and "Guidelines" on page 69.
1
and grasp the SD module by its edges at the same time. Then, lift the
.
Chapter 6 Replacing hardware
97