Front Panel Block - Sony HT-GT1 Service Manual

2-4.

FRONT PANEL BLOCK

rear
side
clamp
MAIN board
5 Insert the jig into the space and slowly
remove the front panel block.
Note 1: When using a jig, please work
carefully so as not to damage
the front panel block and
speaker cabinet.
6 While moving the jig in the direction
of the arrow, remove all bosses and
the front panel block.
7 front panel block
4 connector
(CN3005)
1 Remove the wire
from the clamp.
total eight bosses
3 flexible flat cable (14P)
(CN3003)
2 flexible flat cable (8P)
(CN3002)
5 Insert the jig into the space and slowly
remove the front panel block.
Note 1: When using a jig, please work
6 While moving the jig in the direction
of the arrow, remove all bosses and
the front panel block.
Note 2: When installing the flexible flat cable,
ensure that the colored line is parallel
to the connector after insertion.
Insert straight into the interior.
flexible flat
cable
colored line
connector
flexible flat
cable
colored line
connector
HT-GT1
carefully so as not to damage
the front panel block and
speaker cabinet.
OK
NG
Insert at a slant.
9