Installation; Unpack The Refrigerator - Smeg FAB32UPGRN User Manual

5 Installation

5.1 Unpack the refrigerator

Heavy appliance
Danger of crush injuries
• Use two or more people to move and
install refrigerator. Failure to do so can
result in back or other injury.
Remove the packaging
• Remove tape and glue residue from
surfaces before turning on the
refrigerator. Rub a small amount of liquid
dish soap over the adhesive with your
fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These
products can damage the surface of
your refrigerator.
• On some models, shelves, bins, door
shelf rails, and other feature parts may
be packaged in the Interior FeaturePak.
Follow the instructions contained in the
package for proper assembly.
• Properly dispose of packaging.
26
Installation
When moving your refrigerator
• Your refrigerator is heavy. When moving
the refrigerator for cleaning or service,
be sure to protect the floor.
• Always pull the refrigerator straight out
when moving it.
• Do not wiggle or "walk" the refrigerator
when trying to move it, as floor damage
could occur.
Clean before using
After you remove all of the package
materials, clean the inside of your
refrigerator before using it.
Glass shelves and covers
Do not clean glass shelves or covers with
warm water when they are cold. Shelves
and covers may break if exposed to sudden
temperature changes or impact, such as
bumping.
For your protection, tempered glass is
designed to shatter into many small,
pebble-size pieces. This is normal. Glass
shelves and covers are heavy. Use special
care when removing them to avoid impact
from dropping.