Advertisement
Features:
1 - Strap Button:
2 - Strap Button:
3 - Strap Button:
4 - Strap Button:
5 - Mode Control:
6 - Volume Control:
7 - Coil Tapping Pickup:
8 - Fret Markers:
9 - Slide:
10 - Three-Point "Y" Strap: A Peavey-exclusive design to hold PowerSlide at any angle while standing up.
11 - Output Jack:
How to Use Three-Point Strap:
This three-point "Y" strap is included to help you play your PowerSlide in a horizontal position while standing
up. It is basically an extra-long strap with an adjustable "leg" to help hold the PowerSlide at the most
comfortable playing angle. Inside this manual you will find variations on how to use the strap.
"Y" Strap instructions: (use to the left for reference)
1- Insert Strap Button "1" on guitar into Tab "1s" on the strap.
2- Insert Strap Button "3" on guitar into Tab "3s" on the strap.
3- Insert Strap Button "4" on guitar into Tab "4s" on the strap.
Now you are ready to play your new PowerSlide guitar.
This button is used for either the special "Y" strap or standard shoulder strap.
This button is used with a standard two-point suspension shoulder strap.
This button is used to attach the front of the included three-point strap.
This button is used to attach the adjustable "leg" of the three-point strap.
In place of a TONE control, this knob sweeps the coil-tapping pickup from single
coil to dual coil hum canceling.
Controls output level of the instrument.
Turning the mode control from fully counterclockwise to fully clockwise will range
from hum cancelling with high-end roll off to single coil operation.
Not actual frets but indicators showing positions for proper intonation. The "sail"
patterns are to help easily identify octaves.
Included slide used like typical bar slide/steel.
Used the same as on any electric guitar, to output the signal to an amplifier.
Advertisement
