Panasonic NE-1856-2 Operating Instructions Manual page 13

How to Operate NE - 2156/NE - 1856/NE - 1856-2/NE - 1456
3
Press Number/Memory pad "5".
☛ The selected pad number will appear and currently programmed
5
information will be indicated.
4
Press Power Level Selector pad three times.
☛ The selected power level will be indicated, 1st Stage Heating Indicator
"1" will start to blink, and Heating Time Display will go blank.
5
Press Number/Memory pads "1", "0" and "0".
1 0 0
☛ The set heating time will appear.
Note: up to 15 min. on HIGH or MEDIUM power, 30 min. on DEFROST
6
Press Program pad.
☛ "PROG" and 1st Stage Heating Indicator "1" will stop blinking.
This means that you have completed programming.
• Three seconds later, Digital Display Window will go blank.
Note:
• Program the remaining Number/Memory pads as desired by repeating steps 1-6 above.
• When "PROG" is blinking in Digital Display Window, the program can be cancelled and/or one touch on
Stop/Reset pad erases the programmed Number/Memory pad number.
• When you want to program the B side, press Shift (A/B) pad before selecting the desired Number/Memory pad.
C. PROGRAMMING NUMBER/MEMORY PADS –– 2 or 3 stages heating ––
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see page 13-14)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
Example:To program cooking at DEFROST power for 1 minute and at HIGH power for 2 minutes into Number/Memory pad "5"
PAD
Follow steps 1 to 5 above.
6
Press Power Level Selector pad once.
☛ The power level for 2nd stage will be indicated, 2nd Stage Heating
Indicator "2" will start to blink, and Heating Time Display will go blank.
7
Press Number/Memory pads "2", "0" and "0".
2 0 0
☛ The set heating time will appear.
Note: up to 15 min. on HIGH or MEDIUM power, 30 min. on DEFROST
8
Press Prog pad.
☛ "PROG" and 2nd Stage Heating Indicator "2" will stop blinking. The
total time for both stages will appear. This means that you have
completed programming.
• Three seconds later, Digital Display Window will go blank.
Note:
• Program the remaining Number/Memory pads as desired by repeating steps above.
• When "PROG" is blinking in Digital Display Window, the program can be cancelled and/or one touch on
Stop/Reset pad erases the programmed Number/Memory pad number.
• When you want to program the B side, press Shift (A/B) pad before pressing Number/Memory pad.
INSTRUCTION
- 12 -
PROG
1
PROG
1
PROG
1
PROG
1
DIGITAL DISPLAY WINDOW
PROG
1
PROG
1 2
PROG
1 2
PROG
1 2