Lenovo ThinkCentre M79 User Manual page 108

6. Lift the microprocessor straight up and out of the microprocessor socket.
Figure 50. Removing the microprocessor
Notes:
• Your microprocessor and socket might look different from the one illustrated.
• Note the orientation of the microprocessor in the socket. You can look for the small triangle
on one corner of the microprocessor. This is important when installing the new microprocessor
on the system board.
• Touch only the edges of the microprocessor. Do not touch the gold contacts on the bottom.
• Do not drop anything onto the microprocessor socket while it is exposed. The socket pins must be
kept as clean as possible.
7. Ensure that the small handle is in the raised position.
8. Remove the protective cover that protects the gold contacts of the new microprocessor.
9. Hold the new microprocessor by its sides and align the small triangle on one corner of the new
microprocessor with the corresponding small triangle on one corner of the microprocessor socket.
10. Lower the new microprocessor straight down into the microprocessor socket on the system board.
11. Lower the small handle to secure the new microprocessor in the socket.
12. Reinstall the heat sink and fan assembly with the fan duct. See "Replacing the heat sink and fan
assembly" on page 88.
13. Reconnect all cables that were disconnected from the system board.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 110.
96
ThinkCentre M79 User Guide
1