D-Link DGS-3600 Hardware Installation Manual page 24

Hide thumbs Also See for DGS-3600:

Table of Contents

x Stack

Optional Module Slots

Figure 2 - 5. Optional Module slots at the rear of the DGS-3627 (or DGS-3627G)

Optional Module Slots

After removing the faceplate, remove the DEM-410X or DEM-410CX optional module from its box. The front panel should

resemble the drawings represented here.

Take the module and gently slide it in to the available slot at the rear of the Switch until it reaches the back, as shown in the

following figure. At the back of the slot are two sets of plugs that must be connected to the module. Gently, but firmly push in on

the module to secure it to the Switch. The module should fit snugly into the corresponding receptors.

Now tighten the two screws at adjacent ends of the module into the available screw holes on the Switch. The upgraded

DGS-3627/DGS-3627G/DGS-3650 is now ready for use.

DGS-3600 Series Layer 3 M anaged Gigabit Ethernet Sw itch

Figure 2 - 6. Optional Module slots at the rear of the DGS-3650

Figure 2 - 7. Front Panel of the DEM-410X and the DEM-410CX

Figure 2 - 8. Inserting the optional modules into the Switch

Figure 2 - 9. DGS-3627 with optional module installed

Table of Contents