Sony BDP-N460 Operating Instructions Manual page 28

4
Select a language for the on-screen
displays using
tJ.",
and press
ENTER.
~ Easy Setup - OSD
Select the language to be displayed by this unit
Englistl
FraOf;ais
Espanal
Portugues
The initial settings message appears.
5
Select "Start," and press ENTER.
~ Easy Setup
Set the items below required to use this unit
Each 01 these items may be changed later under ·Setup:
• Select the TV connection method
- Setect the 80 Internet Connection
- Select the Quick Start Mode
Check that all cables, etc. have been connected and then start.
Start
6
Select the cable type used to connect
the player and your TV, and press
ENTER.
~ Easy Setup· TV Connection Method
Select the video cable type connecting this unit and the TV.
HDMI
7
Make the appropriate settings
depending on the cables connected to
your TV.
When you select "HOMI" in step 6
CD
Select "Start," and press ENTER.
The test screen appears for about 30
seconds.
Example: when the video output
resolution is set to 1080i
Easy Setup - Test Screen
Current resolution: 1080i - -_ _
Remaining time: xx more seconds
(,-_;.::.Fin;;.:;ISh,--~
Current video output resolution setting
"
If no picture appears, press RETURN to
return to step 6, and select "Component
Video."
®
Select "Finish," and press ENTER.
The display asks for confirmation.
®
Select "OK" or "Cancel," and press
ENTER.
"
W hen connecting the HDMI OUT jack and
other video output jacks at the same time,
select "Component Video."
~
Easy Setup· Component Resolution
When you select "Component Video" in
step 6
CD
Select a video output resolution for
the connected TV, and press ENTER.
For details about the video output
resolution, see page 45.
...
Component Video
Video
=
...
Select the resolution to output to the TV.
The video switches for 30 seconds when this setting is changed.
Check thaI there are no problems with the video.
Nothing is displayed on the screen if the resolution is incorrect.
480;
480p
720p
10801
28
The test screen appears for about 30
seconds. For the test screen, see
"When you select "HDMI" in step 6"
(above).