Using The Control Panel - Samsung rf858valasl User Manual

operating your samsung
refrigerator

USING THE CONTROL PANEL

1
2
3
9
7
( 1 ) CoolSelect
The CoolSelect button lets you set the Cool
Select Room on the bottom right of your
refrigerator to one of four settings: Freezer, Soft
Freezing, Chill, or Cool.
Press the CoolSelect button for three seconds to
activate the Cool Select Room function, and then
select one of the four settings.
Select Freezer to set the Cool Select
Room to the same temperature as
Freezer
the freezer.
• Use this setting to keep frozen
food fresh.
Soft
• Select Soft Freezing to set the
Freezing temperature in the Cool Select
Room to -5 °C. This feature helps
keep meat and fish fresh longer.
Chill
• Select Chill to set the temperature
of the Cool Select Room to -1 °C.
• Select Cool to set the temperature
Cool
of the Cool Select Room to 5 °C.
You can keep water, juice, soft
drinks, beer, etc. cold.
( 2 ) Freezer (Hold 3 sec for Power Freeze)
Touch this button to set the freezer
to your desired temperature.
You can set the temperature between
-23 °C and -15 °C.
DA68-02836K (EN)-08.indd 23
4
5
6
8
(Cool Select Room)
+
Touch and hold this button for
3 seconds to decrease the time
needed to freeze products in the
Freezer. This can be helpful if you
need to quickly freeze easily spoiled
items or if the temperature in the
freezer has warmed dramatically (For
example, if the door was left open).
( 3 ) Alarm (Hold 3 sec for Filter Reset)
This button serves two purposes:
1) To turn the door open alarm on
and off
If the door alarm is set to On, an
alarm beeps if any refrigerator
door is left open for more than two
minutes.
The beeping stops when you close
the door. The door alarm function
is pre-set to On in the factory.
You can turn it off by touching and
then releasing this button.
You can turn it back on in the
same fashion. The icon lights up
when the function is on.
When the Door Alarm function
is on and the alarm sound is
triggered, the Door Alarm Icon will
blink while the alarm sounds.
2) To reset the water filter life indicator.
After you replace the water filter,
touch and hold this button for 3
seconds to reset the water filter
life indicator.
( 4 ) Energy Saver (Hold 3 sec for °C↔°F)
Touching this button turns Energy
Saver mode on and off. When you
turn Energy Saver on, the Energy
Saver icon lights.
Turn Energy Saver off and the icon
goes off. The Energy Saver function
is set to "ON" in the factory.
If condensation or water drops
appear on the doors, turn the Energy
Saver mode off.
Touch and hold this button for 3
seconds to switch the temperature
units between °C and °F.
operating _23
2015. 8. 26. 11:37