Connecting To Web-Based Interface - D-Link DSL-2750U User Manual

DSL-2750U Wireless N ADSL2+ USB Modem Router
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (for example, create an interface to connect to the Internet, change the
parameters of the wireless network, specify the settings of the firewall, etc.)
1. Start a web browser (see the Before You Begin section, page 16).
2. In the address bar of the web browser, enter the IP address of the router (by default, the
following IP address is specified: 192.168.1.1). Press the Enter key.
Figure 16. Connecting to the web-based interface of the DSL-2750U device.
3. On the opened page, enter the username and password for the administrator account in the
Login and Password fields correspondingly (by default, the following username and
password are specified: admin, admin). Then click the Enter link.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
For security reasons, it is strongly recommended to change the administrator password
!
upon initial configuration of the router . To do this, click the Advanced settings link and
proceed to the System / Administrator password page.
Figure 17. The login page.
Page 30 of 174
Installation and Connection