Din Rear-Mount - Pioneer DVH-P4100UB Installation Manual

Removing the Unit
1. Extend top and bottom of the trim ring outwards
to remove the trim ring. When reattaching the
trim ring, push the trim ring onto the unit until it
clicks. (If the trim ring is attached upside down,
the trim ring will not fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
2. Insert the supplied extraction keys into both sides
of the unit until they click into place.
3. Pull the unit out of the dashboard.
Downloaded from Caradio-Manual.com Manuals
Trim ring

DIN Rear-mount

1. Extend top and bottom of the trim ring outwards
to remove the trim ring. When reattaching the
trim ring, push the trim ring onto the unit until it
clicks. (If the trim ring is attached upside down,
the trim ring will not fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
2. Determine the appropriate position where the
holes on the bracket and the side of the unit
match.
3. Tighten two screws on each side.
• Use either truss screws (5 mm
flush surface screws (5 mm × 9 mm), depend-
ing on the shape of screw holes in the
bracket.
Factory radio mounting bracket
Trim ring
× 8 mm) or
Screw
Dashboard or Console
12