Using The Tv Sound Button On The Remote Control - Samsung HT-F4200 User Manual

Media Play
About characters shown in the display
When the display shows PS,or RT signals,the following
characters are used.
• The display window cannot differentiate upper case
and lower case letters and always uses upper case
letters.
• The display window cannot show accented letters,
<A,> for instance, may stands for accented <A's> like
<À, Â, Ä, Á, Å and Ã.>
PTY (Program Type) indication and
PTY-SEARCH function
One of the advantages of the RDS service is that you
can locate a particular kind of program from the preset
channels by specifying the PTY codes.
To search for a program using the PTY codes
K
Before you start!
• The PTY Search is only applicable to preset stations.
• To stop searching any time during the process, press
5 button while searching.
• There is a time limit in doing the following steps.
If the setting is cancelled before you finish, start from
step 1 again.
• When pressing the buttons on the primary remote
control, make sure that you have selected the FM
station using the primary remote control.
+
RDS DISPLAY
2
1
PTY - PTY SEARCH
4 5
1. Press the PTY SEARCH button while listening to an
FM station.
2. Press the PTY- or PTY+ button until the PTY code
you want appears on the display.
• The display gives you the PTY codes described
to the right.
3. Press the PTY SEARCH button again, while the
PTY code selected in the previous step is still on the
display.
• The centre unit searches 15 preset FM stations,
stops when it finds the one you have selected,
and tunes in that station.
28
|
English
You can listen to TV's audio via Home cinema speakers
or TV Speaker by TV SOUND button.
1.
2.
3.
4.
K
K
TA
3
PTY +
6
Using the TV Sound Button on the
Remote Control
TV Sound
Connect the HDMI cable to TV and Home cinema.
(See page 15)
Set the connected Home cinema and TV to
Anynet+ (HDMI-CEC) On.
Press the TV SOUND button on the remote control.
Each time you press the TV SOUND button, TV
SOUND ON/OFF flashes shortly on the Display part
on the Front panel, then changes to D.IN.
- TV SOUND ON : Output to Home cinema
speakers.
- TV SOUND OFF : Output to Anynet+ connected
TV Speaker.
Use in this case:
1) When you want to listen to the TV's audio via home
cinema speakers.
2) When you want to listen to the sound from the USB
media that plugged to the TV via home cinema
speakers
TV SOUND ON/OFF support specification
Anynet+
Connected TV (HDMI-CEC)
Setting
Anynet+ ON
(HDMI-CEC)
supported TV OFF
Anynet+
(HDMI-CEC) not No operation
supported TV
TV SOUND
TV TV
Sound Sound
ON OFF
O O
O X
O X