Care And Cleaning - Siemens ET375GU11E Operating Instructions Manual

30 cm wide lava grill
Hide thumbs Also See for ET375GU11E:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 17

Care and cleaning

Draining the water
Cleaning the metal parts
Cleaning the grid iron
Lava stones
Do not use high-pressure or steam jet cleaning
devices.
Caution, risk of burns! Wait until the grill has
cooled down completely before cleaning it.
Clean the grill after every use. Burnt in residues may
be difficult to remove.
Wash new sponge cloths thoroughly before use.
In the event that the water is still hot when drained,
add some cold water to the container to cool it!
To drain the water, place a heat-resistant container
beneath the drain valve. Open the drain tap by
turning the lever down by 90°. Then close the tap by
turning the lever fully up.
Wipe clean the metal surfaces using warm soapy
water. Polish with a clean, dry cloth.
Avoid scratching or scrubbing as this could cause
permanent scratches. Remove stubborn soiling with
a soft brush or soak with a small amount of soapy
water.
The grid iron can be cleaned by hand by adding a
mild detergent to the cleaning water. Do not apply
acidic substances (lemon juice, vinegar, etc.) to the
enamel surface.
Do not scrape away burnt in residues but soak with
a small amount of soapy water.
It is advisable to dry very damp lava stones
occasionally in the oven at 200 °C. This will prevent
the formation of mildew.
29

Advertisement

Table of Contents
loading

Table of Contents