Table of Contents
Advertisement
Available languages
Available languages
conditions and duration of use, noise from this product may contribute to
hearing loss.
SAFETY GUIDELINES - DEFINITIONS
It is important for you to read and understand this manual. The information it contains
relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols
below are used to help you recognize this information.
DANGER:
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING:
result in death or serious injury.
CAUTION:
Indicates a potentially haz ard ous situation which, if not avoided, may
result in minor or mod er ate injury.
CAUTION:
Used without the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
The label on your tool may include the following symbols.
V ..........................volts
Hz ........................hertz
min ........................minutes
......................direct current
.......................... Class II Construction
........................safety alert symbol
MOTOR
Be sure your power supply agrees with nameplate marking. Lower voltage will cause
loss of power and can result in over-heating. All Black & Decker tools are factory-tested;
if this tool does not operate, check the power supply.
Extension Cords
When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gage. The smaller the gage number, the heavier the cord.
Volts
120V
220V
Ampere Rating
More
Than
0
6
10
12
FUNCTIONAL DESCRIPTION
1. On/off switch
2. Dust extraction outlet
3. Sanding base
4. Paper clamp lever
5. Hole Punch
Indicates a potentially hazardous situation which, if not avoided, could
Minimum Gage for Cord Sets
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
-
6
18
-
10
18
-
12
16
-
16
14
A..........................amperes
W ........................watts
n o ........................no load speed
.../min ..................revolutions or
Total Length of Cord in Feet
26-50
51-100
51-100
101-200
American Wire Gage
16
16
16
14
16
14
12
Not Recommended
19
......................alternating current
........................earthing terminal
reciprocations per minute
101-150
201-300
14
12
12
Advertisement
Table of Contents
