Advertisement
Available languages
Available languages
5.
Metho d o f roll pa per se tting form
(1) Hold the release lever between your thumb and other fingers.
Note 1:
When manipulating the top cover, note that the cover seems to lock in position before it is open completely.
Make sure that the cover is open completely as shown in the picture below.
Note 2:
If the top cover is not open completely, it may close by itself.
Note 3:
Do not touch the thermal head. Otherwise it may be damaged by static electricity.
Roll holder
(2) Adjust the separator to the width of the roll paper.
Note :
At the time of shipment from the factory, the separator is set at a position appropriate for a paper width of
70mm. Refer User's Manual "5. Inserting Paper for Printing" for the position adjustment of Separator.
(3) Peel off the paper or the sheet that is glued to the roll paper.
Note :
Since the glued portion of the paper should not be printed on, remove one turn (approximately 40 cm) of the
Roll paper from the beginning so that none of the remaining paper has glue on it.
Any adhesive or other material remaining from the glue may adhere to the thermal head and cause a problem,
such as voids on printouts. Therefore, do not forget to remove the glued portion of the paper.
(4) Set the roll paper as shown in the figure, and pull the end of the paper toward the front of the printer.
Note 1:
Set Roll Paper, pull out the paper from the front side of Printer, and close Top cover (Fig.a)
Note 2:
Using roll paper such as that shown in the figure below may cause a paper jam, uneven printing, or other
printing problems. (Fig.b,c)
Thermal
Release lever
Top cover
Separato
r
Top part of the top cover
Bottom part of the
cover release lever
Advertisement
