Inserting And Removing A Disc - Canon HR10 Instruction Manual

Inserting and Removing a Disc

Use only 8 cm mini DVD discs marked
with the DVD-R
DVD-R DL) or the DVD-RW
Refer also to Recommended discs
( 5).
Before inserting the disc be sure to
check that the recording surface is
clean. If necessary, use a soft lens-
cleaning cloth to remove any
fingerprints, dirt buildup or smudges
from the disc surface.
Inserting the Disc
POINTS TO CHECK
Pick up lens
1
Move the
set the camcorder in
mode.
OPEN
2
Slide fully in the direction of
the arrow and gently open the disc
cover completely until it stops.
Retract the grip belt under the
camcorder so it will not get in the
way of the disc cover.
logo (including
logo.
( 23)
switch to ON to
3
Insert the disc and press its center
firmly until it clicks in place.
• Insert the disc with the recording
side facing down (single sided
discs – label side facing out).
• Be careful not to touch the
recording surface of the disc or the
pick up lens.
4
Close the disc cover.
Do not force the cover closed if the
disc is not correctly inserted and
firmly set in place.
NOTES
• The process of recognizing a disc may
take a moment. The
move while the disc is being read. Wait
until the camcorder finishes recognizing
the disc before you start recording.
• Do not insert into the camcorder discs
that were recorded or initialized using
another device.
W
HEN YOU INSERT A NEW DISC
You need to initialize new discs before
you can start recording. The disc
initialization screen will appear when a
new disc is first inserted if the
switch is set to
display will
/
(Movies).
29