Table of Contents
Advertisement
VC720024MUK Rev1.qxp_Instruction Booklet 12/08/2014 10:20 Page 7
Using in upright steam cleaning mode (continued)
Place the floorhead
floorhead to the floor with your foot and tilt the
main body
(7)
back.
To emit steam continually, press and hold the
steam trigger
(2)
back and forth along the floor. But to prevent
over-wetting of the floor, operate the steam
trigger intermittently (especially on hard floors).
Using the handheld steam cleaner
This function is ideal for cleaning vertical
surfaces and hard to reach places.
Separate the handheld steam cleaner
the main body
(7)
release button
(6)
main body.
Pull the handheld steam cleaner up and out of
the main body.
In order to use all of the accessories, the
accessory adaptor
onto the handheld steam cleaner (9). This can be
done by completing the following:
Slide the adaptor over the nozzle of the steam
cleaner with the release catch on the adaptor
facing the base of the handheld steam cleaner.
Align the keyway on the handheld steam cleaner
with the release catch on the adaptor. Push
together and fix into place.
B
Attach the desired accessory to the end of the
adaptor by aligning the arrow on the accessory
(20)
on the floor. Hold the
whilst slowly pushing the cleaner
(9)
from
by sliding the handheld
upwards on the front of the
(24)
must firstly be attached
5
If cleaning carpet, push and clip the floorhead
(20)
with the micro-fibre carpet cloth
attached into the carpet glider (21).
NOTE: The carpet glider is designed to make it
easier to move the floorhead across the carpet.
A
24
B
with the right-hand arrow on the adaptor and
twist the accessory until the arrow aligns with the
left arrow of the two on the adaptor.
NOTE: handheld mode has been designed for
one-handed use.
Warning
WARNING: Switch OFF and unplug before
changing nozzles. After use, nozzles will be
very hot, allow to cool before handling.
WARNING: When using in the handheld mode,
only ever hold the product by the handheld
handle (8).
The underside of the handheld steam cleaner
will become warm during use - this is normal.
Never place the product on delicate surfaces that
could be affected by heat.
Never block any nozzle, eg. by holding against a
surface being cleaned. If the nozzles are blocked,
steam will be released from the steam relief vent
(16).
6
(22)
B
24
(9)
7
Advertisement
Table of Contents
