Install The Adapter/Damper - Broan ESB10 Installation Instructions & Use And Care

5. INSTALL THE ADAPTER/DAMPER

NOTE: If this hood replaces another one, please note that the location of the air exhaust can vary from
one manufacturer to another.
HORIZONTAL DISCHARGE,
NEW INSTALLATION
Fold down the foldable flange (A) of the
adapter/damper. This flange must be at 90°
from the remaining flanges. Use the lower
screw holes on each side of the adapter/
damper to assemble it to the back of hood.
See below.
HJ0006
VERTICAL DISCHARGE
For a vertical discharge installation only, leave the
foldable flange (A) of the adapter/damper as is. This
flange must be located towards the front of the hood.
See illustration at right.
ALL INSTALLATIONS
Using two 1/2" screws, secure the adapter/damper to
the top or back of the hood. Seal the adapter/damper
to the hood using metal foil duct tape.
NOTES: 1. For the best ventilation performance, if a round duct must be used, the duct diameter must
be 6" or more. Use a 3¼" x 10" to 6" round transition.
2. The wall duct must be well prepared to receive the adapter. Before performing the installation,
make sure the adapter fits easily in the duct, and both adapter/damper and roof or wall cap
open and close freely.
A
HORIZONTAL DISCHARGE,
HOOD REPLACEMENT
It may be necessary to adjust the adapter/
damper location to the existing wall discharge
opening. Leave the foldable flange (A) of the
adapter/damper as is. Use the upper screw
holes on each side of the adapter/damper to
assemble it to the back of hood. See below.
A
HJ0007
HO0057
HO0058
7
A