Husqvarna K6500 Ring Operator's Manual page 11

• Press in the guide roller if necessary, so that it climbs
into the groove on the blade.
• Fit the support roller guard and ensure that the
flanges on the guide rollers still enter the blade's
grooves correctly.
• Now tighten the four screws fully.
• Rotate the blade and make sure that the support
rollers are not clamped against the blade.
CAUTION! The machine should be upright. If the
machine lies on its side the weight of the blade makes it
difficult to make a correct adjustment. Incorrect
adjustment can result in damage to the blade. If the
blade rotates slowly or stops, stop cutting immediately
and trouble shoot.
• Adjust the adjuster screws so that the support rollers
make contact against the blade.
ASSEMBLING AND ADJUSTMENTS
• Adjust so you can easily stop the support rollers using
your thumb when the blade is rotated. The support
rollers should only follow the blade occasionally.
• Tighten the locking nuts on the support roller guard.
• Rotate the blade and make sure you can still hold the
rollers with your thumb when the blade is rotated.
• Tighten the knobs fully and the machine is ready to
use.
–
English 11