Connection Of Rails; Assemble The Rail - Husqvarna WS220 Operator's Manual

Connection of rails

1
2
3
4
5
1 Gear rack
2 Steering prism for saw carriage guide wheels.
3 Splice connector, rail
4 Clamping surface for wall mounting.
5 Excenter bolt
6 Endstopper, rail
• Mount the splice connector on the end of a rail. Put an
ex-center bolt in the hole on the underside of the rail.
Make sure that the marking on the bolt is centered
over the symbol with the open padlock. The bolt
should be pushed in all the way so that the head is flat
against the rail. Lock the bolt by turning it clockwise
towards the symbol with the locked padlock. Tighten
to 40 Nm.
• Mount the other rail on the same splice connector so
that both rails meet. Lock it in the same way with
another ex-center bolt.
In one end of the completed rail there is a secured end
stopper. In the other end a loose end stopper is mounted
as in the illustration. The stopper is locked using the ex-
center bolt in the same way as the splice connector.
14 – English
ASSEMBLING AND ADJUSTMENTS
6

Assemble the rail

• Make sure that the expander bolt does not extend
beyond the surface of the rail on the wall bracket.
• Snap the rail into both wall brackets. Adjust the rails'
position lengthwise, and then tighten the clamping
washers on the wall brackets to 40 Nm.
• Make sure that the cutting line is 80 mm (3.15') from
the wall bracket. Make sure that the expander bolts
are tightened by 40 Nm.
• Adjust the blade angle as needed against the
concrete surface by loosening the locking screw for
angle adjustment and angling both wall bracket halves
in relation to each other.