Host Configuration - NETGEAR GS716T Software Administration Manual

5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.

Host Configuration

Use this page to manually map host names to IP addresses or to view dynamic DNS
mappings.
To access this page, click System
To add a static entry to the local DNS table:
1. Specify the static host name to add. Each substring must be less than 64 characters in
length separated by a dot or space, and the length of the whole string must not exceed
158 characters.
2. Specify the IP address in standard IPv4 dot notation to associate with the host name.
3. Click Add. The entry appears in the list below.
4. To remove an entry from the static DNS table, select the check box next to the entry and
click Delete.
5. To change the host name or IP address in an entry, select the check box next to the entry
and enter the new information in the appropriate field, and then click Apply.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
GS716T and GS724T Gigabit Smart Switches
Management

48
DNS Host Configuration.
 