Panasonic KX-TDE600 Installation Manual page 227

System Initialisation Procedure
1.
Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
2.
Plug the AC power cord into the PBX and an AC outlet, and turn on the PBX. The RUN indicator will flash.
Note
For safety reasons, do not stretch, bend, or pinch the AC power cord.
3.
While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the PBX as well as all optional service cards (except for the IP-GW card) will be
initialised to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW card will not be initialised.
Note
When initialising the PBX, the built-in ESVM card will also be initialised. Therefore, the built-in ESVM card
feature may not be used for up to 2 minutes after the PBX starts.
RUN Indicator
To AC Outlet
Reset Button
RESET
SYSTEM
INITIALIZE
NORMAL
System Initialise Switch
3.15.1 Starting the PBX
Installation Manual 227