Operation - ULTIMATE SPEED UAMM 12 A1 Operating Instructions Manual

RP69011 Automass SB2 Seite 5 Freitag, 12. August 2011 9:53 09
3. Plug the mains adapter 13 into a mains
socket that complies with the technical
data.
The remote control
illumination. If this does not come on, the
background illumination will be switched on
first when button 5 , 6 or 7 is pressed for the
first time. Only when the background
illumination is on does the button have the
function described below. The background
illumination goes off again after about 5
seconds.
If you press the OFF button 4 , the device
switches off immediately.
5.1 Switching the device on and off
1. To switch the device on, press the ON
button 6 .
The LCD display 3 shows "MODE 0".
2. To switch the device off, press the OFF
button 4 .
5.2 Selecting a programme
There are 8 programmes (MODE 1 – 8)
available altogether. The programmes vary
in their intensity, the area massaged and the
massage rhythm.
1. Press the MODE programme button 5 .
The device switches
programme and the motors start to
work. The selected programme number
is shown in the LCD display 3 .
The timer counts down the minutes,
beginning at 30 minutes.
The remaining time is shown in the LCD
display 3 .
UAMM 12 A1
4. Plug the power plug 11 on the mains

5. Operation

has background
5.3 Switching the heater on and off
1. To switch the heater on, press the heat
2. To switch the heater off, press the heat
to the next
adapter 13 into the power socket 10 .
As soon as the 30 minutes have expired,
the device switches off automatically.
button 7 .
Heat will now be produced from inside
the massage mat.
The timer continues to count down the
time (see "5.1 Switching the device on
and off" on page 5). The heating
function does not affect the timer.
The heater switches off automatically
after about 30 minutes.
button 7 again.
5