Master/Slave Selection; Linked Or Separate Selection - NorthStar EXPLORER D210 Installation And Operation Manual

Master/Slave Selection

To select the master/slave mode of operation:
ON
1. Apply power while holding down
Hold down during power up
ON
2. When the unit is on. The display will indicate
the current display unit:
example
3. Continue to hold
indicates the current master/slave selection.
Master
4. Use and to change the selection.
5. To exit this mode, press and hold both
simultaneously. Alternatively, if no keys
ON
are pressed for a period of 5 seconds normal
depth display will resume.
ON ON
Press simultaneously
ON
Note: If the data link is inadvertently broken then
the display will alternate between -- and -SL.

Linked or Separate Selection

ON
By default a dual station pair of Explorer D210
instruments automatically keep the following
settings the same in both instruments:
Alarms On/Off
Alarm Values (Deep and Shallow)
Keel Offset (see note)
Units of measure (see note)
Example: Switching an alarm off on the slave
instrument will also switch the alarm off
on the master instrument. The reverse also
applies, alarms changed on the master will be
automatically changed in the slave instrument.
OFF
.
OFF
OFF
until the display
Slave
OFF
OFF
OFF
OFF
OFF
Northstar Explorer D210 Installation and Operation Manual
Note: The keel offset and units of measure should
only be changed on the Master instrument.
If independent settings are required the link
feature can be disabled.
To enable or disable the linked mode:
1. Apply power while holding down
Hold down during power up
2. When the unit is on. The display will first
indicate the current display unit:
ON OFF
3. Continue to hold
ON OFF
the current master/slave selection.
ON OFF
and
ON OFF
4. Continue to hold
indicates the current linked/separate
selection.
5. Use and
6. To exit this mode, press and hold both
simultaneously. Alternatively, if no keys
are pressed for a period of 5 seconds normal
depth display will commence.
Note: This setup procedure applies to the master
device and all slave devices. For separate operation
all devices, including the master, must be set to
Separate mode. Also, for linked operation all devices,
including the master, must be set to Linked mode.
ON OFF
OFF
ON OFF
ON
Example
. The display will indicate
ON
ON
Slave
until the display
ON
Linked Separate
to change the selection.
ON OFF
OFF
ON ON OFF
Press simultaneously
ON OFF
ON OFF
.
OFF
ON OFF
OFF
OFF
ON OFF
OFF
ON
and
ON
7