Craig CLC504e Owner's Manual page 4

IMPORTANT SAFETY INSTRUCTIONS
16. Power lines
An outside antenna system should not be located in the vicinity of overhead power lines or
other electric Light or power circuits, or where it can fall into such power lines or circuits.
When installing an outside antenna system, extreme care should be taken to keep from
touching such power lines or circuits as contact with them might be fatal.
17. Overloading
Do not overload wall outlets and extension cords as this can result in a risk of fire or
electric shock.
18. Object and liquid entry
Never push objects of any kind into the product through as they may touch dangerous voltage
points or short out parts that could result in fire or electric shock. Never spill or spray any type
of liquid on the product.
19. Outdoor antenna grounding
If an outside antenna is connected to the product, be sure the antenna system is grounded
so as to provide some protection against voltage surges and built up static charges. Section
810 of the National Electrical Code, ANSI/NFPA 70, provides information with respect to
proper grounding of the mast and supporting structure, grounding of the lead-in wire to an
antenna discharge product, size of grounding conductors, location of antenna discharge
product, connection to grounding electrodes and requirements for the grounding electrodes.
20. Service
Do not attempt to service this product yourself as opening or removing covers may expose
you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
21. Replacement parts
When replacement parts are required, be sure the service technician uses
replacement parts specified by the manufacturer or those that have the
same characteristics as the original part. Unauthorized substitutions may
result in fire or electric shock or other hazards.
6
IMPORTANT SAFETY INSTRUCTIONS
22. Safety check
Upon completion of any service or repairs to this product ask the service
technician to perform safety checks to determine that the product is in
proper operating condition.
23. Wall or ceiling mounting
This product should be mounted to a wall or ceiling only as recommended
by the manufacturer.
24. Damage requiring service
Unplug the product from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled or objects have fallen into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following the operating
instructions.
Adjust only those controls that are covered by the operating instructions,
as an adjustment of other controls may result in damage and will require
extensive work by a qualified technician to restore the product to its
normal operation.
e. If the product has been dropped or the cabinet has been damaged.
f. When the product exhibits a distinct change in performance-this
indicates a need for service.
25. Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to
Article 820-40 of the NEC that provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall be connected to
the grounding system of the building, as close to the point of cable entry
as practical.
Note:
Refer all servicing to qualified service personnel. Servicing is required
when the unit has been damaged in any way such as the following: the
power-supply cord or plug has been damaged, liquid has been spilled
into the unit, the unit has been exposed to rain or moisture, the unit
has been dropped or the unit does not operate normally.
7