Programming the Commands of Other Remote
Control Units into the Remote Controller
Erasing the programmed command
from one button
You can only erase memorized commands and not preset ones.
1
Press and hold down the desired
MODE button for the command,
press the SEARCH button, and
then release both buttons.
When you release the buttons, the SEND/LEARN
indicator lights.
2
Press and release the button for
the command you wish to erase.
When you press the button, the SEND/LEARN
indicator turns off. When you release the button, the
lamp lights again.
3
Press and release the same button
again.
The SEND/LEARN lamp flashes twice. The
memorized command is erased.
Note
If no button is pressed for more than 30 seconds during the programming, the
SEND/LEARN indicator flashes three times quickly, and the remote
controller exits the programming mode. Resume from Step 1.
60
DVD
Erasing all the commands
programmed under a MODE button
1
Press and hold down the desired
MODE button, press the SEARCH
button twice, and then release both
buttons.
When you release the buttons, the SEND/LEARN
indicator flashes twice slowly and then lights again.
Press and release the same MODE
2
button again.
When you release the button, the SEND/LEARN
indicator flashes twice slowly. This erases all the
commands memorized to the MODE button.
Notes
• If no button is pressed for more than 30 seconds, the SEND/LEARN
indicator flashes three times quickly and the remote controller exits the
programming mode. Resume Step 1.
• If you perform an invalid operation during programming, the SEND/
LEARN indicator flashes three times quickly and the remote controller
exits the programming mode. Resume from Step 1.
• If many commands have been programmed to the MODE button, then the
SEND/LEARN indicator may remain lit for some time during Step 2. This
is not a malfunction.
SEND/LEARN
indicator
RECVR
SEARCH