Frigidaire FPGC3087MS Use & Care Manual page 9

SETTING THE DUAL RING BURNER
The Dual Ring Burner has two rings of fl ame that you can
control for two different heat levels, one for small and
one for large cookware.
Large Cookware Operation (Figure 1; Zone A & B)
1. Place a large cooking utensil centered over the dual
surface Burner Grate.
2. Push the surface control knob down and turn
counterclockwise out of the OFF position.
3. Release the knob and rotate to the LITE position
(Figures 2 & 3). Note: All electronic surface ignitors
will spark at the same time. However, only the
selected surface Burner will lit.
4. Visually check that the burner has lit.
5. When the burner is lit, continue to turn the control
knob counterclockwise between the HI position
and the MED position to adjust to the desired fl ame
size for both burners together (fi gure 1). DO NOT
cook with any of the surface control knobs in the
LITE position (The electronic ignitor will continue to
spark if the knob is left in the LITE position).
Figure 3
SETTING SURFACE CONTROLS
Simmering Operation (Figure 1; Zone A)
1. Place a small cooking utensil centered over the dual
surface Burner Grate.
2. Push the surface control knob in and turn
counterclockwise out of the OFF position (See
Figures 2 & 3).
3. Release the knob and rotate to the LITE position.
Note: All electronic surface ignitors will spark at the
same time. However, only the Dual Burner will ignite.
4. Visually check that zone A & B of dual burner
has lit.
5. Continue to turn the gas control knob
counterclockwise past the MED position; zone B will
turn off. Adjust the simmer fl ame size by turning
the control knob between the MED position to the
LO position. DO NOT cook with the surface control
knob in the LITE position (The electronic ignitor
will continue to spark if the knob is left in the LITE
position).
A
B
Figure 1
Figure 2
Figure 4
9