Page 3
Caution: Please read immediately Inspect this power cord and determine if it provides the proper plug and is appropriately certified for use with your electrical system. Immediately discard this cord if it is inappropriate for your country’s electrical system and obtain the proper cord as required by your national electrical codes or ordinances.
Page 4
Installing the Power Supply for the Centillion 100 Chassis Attenzione: Leggere attentamente Controllare questo cavo di alimentazione, verificarne il collegamento con la presa appropriata nonché la certificazione per l'uso nell'impianto elettrico posseduto. Non utilizzare assolutamente in caso tale cavo non sia adatto al sistema elettrico del paese in cui viene utilizzato e richiederne un altro certificato dall'ente nazionale di fornitura elettrica.
Adding a Power Supply CAUTION: Only qualified technicians should install this equipment. Required tool: Flat-tip screwdriver 1. Use the flat-tip screwdriver to loosen the two screws; then remove the filler panel from the chassis. 2. Align the new power supply with the slot guides and slide the power supply into the chassis.
Page 6
4. Connect the power cord to the power supply and then to the wall. (See power cord caution on page 1.) 5. Turn on the power. Verify that the upper (green) LED lights. For detailed instructions, refer to Installation and Reference for the Centillion 100 Chassis. LEDs Power switch 7267 7268 893-00940-A...
Replacing a Power Supply CAUTION: Only qualified technicians should replace this equipment. Required tool: Flat-tip screwdriver Power switch 7269 1. Turn off the power to the faulty power supply and unplug the cord. 7270 2. Use the flat-tip screwdriver to loosen the two screws; then remove the power supply from the chassis.
Page 8
Installing the Power Supply for the Centillion 100 Chassis 7271 3. Align the new power supply with the slot guides and slide it into the chassis. 7272 4. Push down on the power supply handle to align the screws and tighten the screws to between 2 and 4 inch-pounds of torque.
Page 9
5. Connect the power cord to the power supply and then to the wall. (See power cord caution on page 1.) LEDs Power switch 7273.1 6. Turn on the power. Verify that the upper (green) LED lights. For detailed instructions, refer to Installation and Reference for the Centillion 100 Chassis.
Installing the Power Supply for the Centillion 100 Chassis Specifications The following table provides the specifications for the power supply. Electrical Line frequency: Volt Amperes rating: Input voltage: Input current rating: Fuses: Thermal rating One power supply: Multiple power supplies: Physical Dimensions: Handle projection:...