Connecting To Dvi; How To Attach The Ferrite Core - JVC DLA-G150CLE Instructions Manual

Connecting to DVI

Before connection, be sure to turn off both the projector and computer devices.
• Read thoroughly the manual that comes with each device.
DOS/V
(DVI VIDEO BOARD)
Note
• Other connections are the same as in the connection example for IBM PC or IBM compatible PCs.

How to attach the ferrite core

Attach the ferrite core when using the S-video cable or infrared remote sensor extension unit which are sold separately.
However, use a cable that can be wound once.
1
Release the stopper at each end and
open the ferrite core.
2
Wind the cord around the ferrite core.
Attach the ferrite core about 3 cm from the end of the
cord.
3
Close the ferrite core with the cord
inside until you hear it click shut.
Note
• When connecting, connect the terminal which is at the
ferrite core end of the cord to the projector.
DVI (DVI-D 24pin Cable)
(Available separately)
Connecting to Various Devices
R
G
B
H
V
IN
IN
Stoppers
Wind the cable once.
Click!
Y
P
P
29