Display Elements; Technical Data; Assembly; Inserting/Replacing The Battery - Bosch GIM 60 L Professional Original Instructions Manual

OBJ_BUCH-1628-002.book Page 15 Monday, August 27, 2012 12:22 PM

Display Elements

a Alignment aides
b Reading
c Audio signal indicator
d Battery low indicator
e Indicator for changed zero point
f Unit of measure

Technical Data

Digital level
Article number
Measuring range
Measuring accuracy
– 0°/90°
– 1° –89°
Working range of laser
Levelling accuracy of laser
Clearance of laser exit – bottom edge of
measuring tool
Laser class
Laser type
Laser beam diameter (at 25 °C) approx.
– at 5 m distance
– at 10 m distance
Operating temperature
Storage temperature
Relative air humidity, max.
Tripod mount
Batteries
– Grade measurement
– Laser operation
Operating life time, approx.
– Grade measurement
– Laser operation
Weight according to EPTA-Procedure 01/2003
Dimensions (length x width x height)
1) The working range can be decreased by unfavourable environmental conditions
(e.g. direct sun irradiation).
The measuring tool can be clearly identified with the serial number 23 on the type plate.

Assembly

Inserting/Replacing the Battery

The measuring tool has two separate electric circuits: The grade measure-
ment and display are powered by a different battery than the laser.
Alkali-manganese batteries are recommended for the measuring tool.
Remove the batteries from the measuring tool when not using it for
extended periods. When storing for extended periods, the batteries
can corrode and discharge themselves.
Inserting/Replacing the Battery for Grade Measurement
Carefully remove the battery lid 7 with the battery holder from the measur-
ing tool. Pay attention that neither the connection cables of the battery nor
the battery lid become damaged. Damage on the supporting surfaces of the
battery compartment 7 can lead to faulty measurements.
Connect the battery to the battery tray observing the correct polarity. Insert
the battery lid with the battery tray into the measuring tool in such a manner
that the connection cables are not pinched.
When switching on the grade measurement for the first time after changing
the battery, all display elements light up for 1 s and an audio signal sounds.
All saved settings (measuring mode, set unit of measure) are deleted when
changing the battery.
When the battery low indicator d lights up, the battery must be replaced.
Inserting/Replacing the Batteries for the Laser
Fold out the battery lid 20 and insert the batteries. When inserting, pay at-
tention to the correct polarity according to the representation on the inside
of the battery lid.
When the laser no longer lights up, the batteries must be replaced.
Bosch Power Tools
1)
English | 15
GIM 60 L
3 601 K76 300
0–360° (4 x 90°)
±0.05°
±0.2°
30 m
±0.5 mm/m
24 mm
2
635 nm, <1 mW
3.5 mm
6 mm
–10 °C...+50 °C
–20 °C...+70 °C
90 %
1/4"
1 x 9 V 6LR61
2 x 1.5 V LR03 (AAA)
300 h
20 h
0.9 kg
600 x 27 x 59 mm
1 618 C00 62X | (27.8.12)