█
Selecting a preset station
1
Press [PLAY MENU] repeatedly to select
"TUNEMODE".
2
Press [R, T] to select "PRESET" and then press
[OK].
3
Press [2/3] or [5/6] to select the preset
station.
Improving the sound quality
1
Press [PLAY MENU] repeatedly to select
"FM MODE".
2
Press [R, T] to select "MONO" and then press
[OK].
To cancel, select "STEREO".
"MONO" is also canceled when you change the
frequency.
To memorize the setting
Continue with step 4 of "Manual presetting".
Checking the signal status
Press [DISPLAY].
FM – – – –
The FM signal is in monaural.
The system is not tuned in to a station.
FM ST
The FM signal is in stereo.
FM MONO
"MONO" is selected as the "FM MODE".
FM allocation setting
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
1
Press [RADIO].
2
Press and hold [SELECTOR] on the main unit.
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.
10
Clock and timers
Setting the clock
This is a 12-hour clock.
1
Press [SETUP] repeatedly to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select "CLOCK" and
then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
(Except for Bluetooth
®
source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [R, T] to select the source you want to play
and then press [OK].
To start the timer
1
Press [SETUP] repeatedly to select "TIMER SET".
2
Press [R, T] to select "SET" and then press [OK].
"#" is shown.
To cancel, select "OFF".
The system must be switched off for the timer to
operate.
To check the setting
Press [SETUP] repeatedly to select "TIMER ADJ" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The timer starts at a low volume and increases gradually to
the preset level.
•
The timer comes on at the set time every day if the timer is
on.
•
If you switch off the system and then switch on again while
a timer is in operation, the timer will not stop at the end
time.