Replacing The Dustbag - Singer VC2540 Instruction Manual

REPLACING THE DUST BAG
When the indicator shows bleu, then it is time to change the dust bag. Always unplug the appliance
before you replace a dust bag or fi lter.
WARNING: If the dust bag is not fi xed to its proper position, the dust container cover cannot
close.
CLEANING/REPLACING THE FILTERS
a. Pre-motor fi lter
1. Open the air outlet grid and pull the black sponge fi lter out of the appliance.
2. Clean or change the fi lter:
If the sponge fi lter is so dusty that suction does not reach 100%, then it is suggested that the fi lter
is removed, rinsed with lukewarm water and then allowed to dry for 24 hours.
This should be done every six months or when suction appears to be reduced.
All fi lters should be checked regularly, preferably after each cleaning task. The fi lters must be
replaced immediately if they become damaged.
Always disconnect the appliance from the electrical outlet when checking the fi lters.
Note: The sponge fi lter material in the cleaner will become dusty over time. This is normal and will
not affect the performance of the fi lter.
b. Air outlet fi lter HEPA
1. Pull the air outlet grid to open.
2. Take out the white HEPA fi lter to place the new one. This fi lter cannot be cleaned.
1. Remove the fl exible hose.
2. Open the front container cover by push-
ing the front container cover release but-
ton.
3. Remove the dust bag from the holder.
4. When inserting the new dust bag into
the holder make sure to slide it in com-
pletely.
5. Close the front container cover.
6
ENGLISH