Hardware Options; Cable Management System - HP StoreEver Series User Manual

3u rack-mount enclosure

Table of Contents

Figure 3 Enclosure internal SAS cable

1. and 3. Power connectors (used only with LTO-5, LTO-6,

and DAT; do not use with other LTO drives)

2. SAS connector routes device to external port 2

NOTE:

Power for all DDS, LTO-5, and LTO–6 tape drives is supplied through the SAS cable. For

all earlier models of LTO tape drive, plug the power cable directly into the drive.

Hardware Options

For a list of currently supported hardware options, such as tape and DVD drives and media, visit

the HP website at: http://www.hp.com/go/tape.

The 3U Rack-mount Enclosure ships with a cable management system. This system was designed

to better assist you when maintenance is needed.

NOTE:

The cable management system is only for use in 10000, 1 1000, and Intelligent Series

racks.

The following figure shows how the cable management system channels the system cables along

the back of the storage enclosure and to the connection points on the rack.

Figure 4 Cables routed at the rear of the enclosure

Introduction

4. SAS connector routes device to external port 1

5. SAS connector to PC board within the enclosure

Table of Contents