Impact Bolt/Tool Holder (Hr2610/T & 11F/T) - Makita HR2610 Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-6. Impact bolt in Tool holder complete for HR2610/ HR2611F
Tool holder guide complete forHR2610T/ HR2611FT
DISASSEMBLING
(1) Put 1R388 into Tool holder (guide) complete, then push 1R388 in vise with the access holes on Tool holder (guide)
complete parallel to Vise. (Fig. 38)
O-ring case A (HR2610, HR2610T) / O-ring case B (HR2611F, HR2611FT) is moved toward the top of Tool holder
(guide) complete, and therefore, Ring spring 28 can be relieved from O-ring case A/ B.
(2) When the end gap of Ring spring 28 is in the access hole, slide it with slotted screwdriver until it is completely hidden.
(3) Using slotted screwdriver, tap Ring spring 28 through the two access holes alternately to push it out of the inner groove
of Tool holder (guide) complete.
(4) The components are removed by tapping with Phillips screwdriver and plastic hammer from bit installation side of
Tool holder (guide) complete. (Fig. 39)
Fig. 38
Vise
1R388
holes on both side of Tool holder (guide)
complete to access inside
Fig. 39
HR2610 / 2611F
Sleeve 9A
Bit
installation
Impact
side
bolt A
Ring 10A
Cushion ring 12
Sleeve 9B
HR2611F
Washer 10
Compression
spring 20
O-ring case B
The directions of two access holes on Tool holder (guide) complete
have to be parallel to Vise.
1R388
O-ring case A (HR2610, HR2610T) / B (HR2611F, HR2611FT)
HR2610
O-ring case A
Inner
housing
O ring 9
complete
side
Ring spring 28
Note: Refer to Fig. 40A/ 40B for the details.
90°
slotted
screwdriver
inner groove of Tool holder (guide) complete
Ring spring 28
Bit
installation
side
Impact bolt B
Sleeve 9B
HR2611FT
Washer 10
Compression
spring 20
O-ring case B
Vise
HR2610T / 2611FT
HR2610T
Ring 10B
Cushion ring 12
O-ring case A
O ring 9
Ring spring 28
P 13/ 22
Inner
housing
complete
side