Samsung GT-B7702 Service Manual page 75

11-2 Assembly
1
< Figure 1 >
1) Assemble SUB KEY on Front. [Figure 1]
2) Assemble LCD on FRONT at assembly mark.[Figure 2]
1) Be careful not to damage TSP FPCB.
2) Assembling LCD, be careful not to get dust.
3
< Figure 1 >
1) Assemble Sheild can on correct clip.[Figure 1]
1) When assembling Sheild can, Be careful not to damage
.
component nearby connector
2) Make sure the assembling, After assembling Sheild can
5
Screw(M1.4, L3.5)
1.0 ~
Torque
1.2Kgf.cm
< Figure 1 >
1) Screw 5 Points. [Figure 1]
1) Screw on correct place.
< Figure 2 >
Sheild can
Clip
< Figure 2 >
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
2
Sub Key
Connector
< Figure 1 >
1) Assemble SUB KEY FPCB connector to PBA.[Figure 1]
2) Assemble PBA on Bracket.[Figure 2]
1) Make sure KEY FPCB connector no to take off.
4
Speaker
< Figure 1 >
1) Assemble Speaker FPCB connector.[Figure 1]
2) Lift Speaker, assemble hooking the PBA.[Figure 2]
1) Be careful not to damage Motor FPCB and other parts.
2) Double check Motor Bracket assembling.
6
5M Camera
< Figure 1 >
1) Assemble 5M Camera.[Figure 1]
2) Assemble Camera connector.[Figure 2]
1) Assembling Camera, Be carful about FPCB damage and
Connector combining
11-3
Exploded View and Parts List
< Figure 2 >
hook
< Figure 2 >
Cam Connector
< Figure 2 >